Abstract:CaNdAlO4 microwave dielectric ceramics were modified by Ca/Ti co-substitution, and their dielectric characteristics were evaluated along with their structure and microstructures. Ca1+xNd1-xAl1-xTixO4 (x=0, 0.025, 0.05, 0.10, 0.15, 0.20) ceramics with the relative density of over 95% theoretical density were obtained by sintering at 1400 degrees-1450 degrees C in air for 3 h, where the K2NiF4-type solid solution single phase was determined from the compositions of x<0.20, while a small amount of CaTiO3 secondary phase was detected for x=0.20. With Ca/Ti co-substitution in CaNdAlO4 ceramics, the dielectric constant (epsilon(r)) increased with increasing x, and the temperature coefficient of resonant frequency (tau(f)) was adjusted from negative to positive, while the Q x f(0) value increased significantly at first and reached an extreme value at x=0.025 and the maximum at x=0.15. The best combination of microwave dielectric characteristics were achieved at x=0.15 (epsilon(r)=19.5, Q x f(0)=93 400 GHz, tau(f) = -2 ppm/degrees C). The improvement of the Q x f(0) value primarily originated from the reduced interlayer polarization with Ca/Ti co-substitution, while the decreased tolerance factor, the subsequent increased interlayer stress, and the appearance of CaTiO3 secondary phase brought negative effects upon the Q x f(0) value.

Temperature Compensated (1-x)(Na<sub>0.5</sub>La<sub>0.5</sub>)TiO<sub>3</sub>+xCeO<sub>2</sub> Microwave Dielectric Ceramics Incorporated with Copper Oxide

Temperature Compensated (1-x)(Na<sub>0.5</sub>La<sub>0.5</sub>)TiO<sub>3</sub>+xCeO<sub>2</sub> Microwave Dielectric Ceramics Incorporated with Copper Oxide

Temperature compensated (1-x)(Na0.5La0.5)TiO 3+xCeO2 microwave dielectric ceramics incorporated with copper oxide

Microwave Dielectric Properties of Temperature Stable (1-X)srlaalo4-xtio2 Composite Ceramics

Temperature Stability of Low-Temperature Fired (1-X) ZnTiNb2O8-xCuTiNb2O8 Microwave Dielectric Ceramics

Composite Dielectrics (1−x)(mg0.97zn0.03)2(ti0.95sn0.05)o4−xcatio3 Suitable for Microwave Applications

Sm2-xCexO3+x/2 Composite Microwave Dielectric Ceramics with Tunable Τf and Enhanced Qxf

Temperature Compensating Microwave Dielectric Based on the (mg 0.97 Co 0.03 ) 2 (ti 0.95 Sn 0.05 )O 4 –catio 3 Ceramic System

Sm2-xCexO3+x/2 Composite microwave dielectric ceramics with tunable τf and enhanced Q×f

High-permittivity Microwave Dielectric Ceramics Based on (1 - X)(li1/2nd1/2)tio3–xcatio3

Microwave Dielectric Properties of (1-x)(Ca0.61Nd0.26)TiO3–x(Li0.5Sm0.5)TiO3

Microwave Dielectric Properties of (1-X)(ca<sub>0.61</sub>nd<sub>0.26</sub>)tio<sub>3</sub>–x(li<sub>0.5</sub>sm<sub>0.5</sub>)tio<sub>3</sub>

Temperature Stability of Li2TiO3‐Zn2SiO4 Microwave Dielectric Ceramics

Preparation and characterization of Ba 0.2 Sr 0.8 La 4 Ti 4+x O 15 microwave dielectric ceramics

Sm2-Ce O3+/2 Composite microwave dielectric ceramics with tunable τ and enhanced Q×f

Microwave dielectric characterization of Ca0.6(La1-xYx)0.2667TiO3 perovskite ceramics with high positive temperature coefficient

Low Temperature Sinter-Ability of Microwave Dielectric Ceramics 0.4(Ca<sub>0.61</sub>Nd<sub>0.26</sub>)TiO<sub>3</sub>-0.6(Li<sub>0.5</sub>Sm<sub>0.5</sub>)TiO<sub>3</sub>

Composite dielectrics (1−x)(MgZn)(TiSn)O−xCaTiO suitable for microwave applications

Structure And Microwave Dielectric Characteristics Of Ca1+Xnd1-Xal1-Xtixo4 Ceramics

Microwave Dielectric Properties and Low Sintering Temperature of Ba0.5Sr0.5TiO3–Mg2TiO4 Composites Synthesized in Situ by the Hydrothermal Method

Temperature Compensated (1-x)(Na&lt;sub&gt;0.5&lt;/sub&gt;La&lt;sub&gt;0.5&lt;/sub&gt;)TiO&lt;sub&gt;3&lt;/sub&gt;+xCeO&lt;sub&gt;2&lt;/sub&gt; Microwave Dielectric Ceramics Incorporated with Copper Oxide

Temperature Compensated (1-x)(Na<sub>0.5</sub>La<sub>0.5</sub>)TiO<sub>3</sub>+xCeO<sub>2</sub> Microwave Dielectric Ceramics Incorporated with Copper Oxide

Temperature compensated (1-x)(Na0.5La0.5)TiO 3+xCeO2 microwave dielectric ceramics incorporated with copper oxide

Microwave Dielectric Properties of Temperature Stable (1-X)srlaalo4-xtio2 Composite Ceramics

Temperature Stability of Low-Temperature Fired (1-X) ZnTiNb2O8-xCuTiNb2O8 Microwave Dielectric Ceramics

Composite Dielectrics (1−x)(mg0.97zn0.03)2(ti0.95sn0.05)o4−xcatio3 Suitable for Microwave Applications

Sm2-xCexO3+x/2 Composite Microwave Dielectric Ceramics with Tunable Τf and Enhanced Qxf

Temperature Compensating Microwave Dielectric Based on the (mg 0.97 Co 0.03 ) 2 (ti 0.95 Sn 0.05 )O 4 –catio 3 Ceramic System

Sm2-xCexO3+x/2 Composite microwave dielectric ceramics with tunable τf and enhanced Q×f

High-permittivity Microwave Dielectric Ceramics Based on (1 - X)(li1/2nd1/2)tio3–xcatio3

Microwave Dielectric Properties of (1-x)(Ca0.61Nd0.26)TiO3–x(Li0.5Sm0.5)TiO3

Microwave Dielectric Properties of (1-X)(ca&lt;sub&gt;0.61&lt;/sub&gt;nd&lt;sub&gt;0.26&lt;/sub&gt;)tio&lt;sub&gt;3&lt;/sub&gt;–x(li&lt;sub&gt;0.5&lt;/sub&gt;sm&lt;sub&gt;0.5&lt;/sub&gt;)tio&lt;sub&gt;3&lt;/sub&gt;

Temperature Stability of Li2TiO3‐Zn2SiO4 Microwave Dielectric Ceramics

Preparation and characterization of Ba 0.2 Sr 0.8 La 4 Ti 4+x O 15 microwave dielectric ceramics

Sm2-Ce O3+/2 Composite microwave dielectric ceramics with tunable τ and enhanced Q×f

Microwave dielectric characterization of Ca0.6(La1-xYx)0.2667TiO3 perovskite ceramics with high positive temperature coefficient

Low Temperature Sinter-Ability of Microwave Dielectric Ceramics 0.4(Ca&lt;sub&gt;0.61&lt;/sub&gt;Nd&lt;sub&gt;0.26&lt;/sub&gt;)TiO&lt;sub&gt;3&lt;/sub&gt;-0.6(Li&lt;sub&gt;0.5&lt;/sub&gt;Sm&lt;sub&gt;0.5&lt;/sub&gt;)TiO&lt;sub&gt;3&lt;/sub&gt;

Composite dielectrics (1−x)(MgZn)(TiSn)O−xCaTiO suitable for microwave applications

Structure And Microwave Dielectric Characteristics Of Ca1+Xnd1-Xal1-Xtixo4 Ceramics

Microwave Dielectric Properties and Low Sintering Temperature of Ba0.5Sr0.5TiO3–Mg2TiO4 Composites Synthesized in Situ by the Hydrothermal Method

Temperature Compensated (1-x)(Na<sub>0.5</sub>La<sub>0.5</sub>)TiO<sub>3</sub>+xCeO<sub>2</sub> Microwave Dielectric Ceramics Incorporated with Copper Oxide

Microwave Dielectric Properties of (1-X)(ca<sub>0.61</sub>nd<sub>0.26</sub>)tio<sub>3</sub>–x(li<sub>0.5</sub>sm<sub>0.5</sub>)tio<sub>3</sub>

Low Temperature Sinter-Ability of Microwave Dielectric Ceramics 0.4(Ca<sub>0.61</sub>Nd<sub>0.26</sub>)TiO<sub>3</sub>-0.6(Li<sub>0.5</sub>Sm<sub>0.5</sub>)TiO<sub>3</sub>