Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

A Simulation Modeling Method Considering the Quench Characteristics of Superconducting Cable

Transient Analysis of HVDC HTS Cable in Power Grid Using Discretized Electrical-Thermal Model

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

Research on Structure Optimization of Cold Dielectric High-Temperature Superconducting Cables

High-Speed Transmission Cable Performance- Simulations and Measurements

3D quench modeling based on T-A formulation for high temperature superconductor CORC cables

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Research on Fault Current Endurance Capability of Concentric HTS Cable

Intelligent surrogate model of a high temperature superconducting cable for reliable energy delivery: Short circuit fault performance

HTS Cable Design for Aircraft Application Considering Fault Conditions

Numerical Analysis on the Current Distribution and the Loss in HTS Stacked Tapes Considering Termination Resistances

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Temperature Analysis of HTS Cables in Superconducting DC Energy Pipeline During Short-circuit Fault

Research on overcurrent stability of HTS cable for energy pipeline

Reliability Analysis of HTS Cable Systems

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

Design and Performance Tests of a Fault Current-Limiting-Type Tri-Axial HTS Cable Prototype

Full 3D thermal-hydraulic and electric modelling of quench propagation in HTS conductors

Investigations on Quench Recovery Characteristics of High-Temperature Superconducting Coated Conductors for Superconducting Fault Current Limiters