Abstract:Black phosphorus has attracted broad interest because of their low-dimensional effect, and has become a new kind of two-dimensional (2D) materials. Phosphorus has several allotropes. Black phosphorus is the most thermodynamic stable in them. As a kind of two-dimensional materials, black phosphorus has high carrier mobility and on/off ratio. The band gap of black phosphorus can be adjusted by its number of layers from 0.3 to 2 eV. It is of great significance to the development of new infrared and near-infrared optoelectronic devices. Currently, the main methods for preparing black phosphorus are chemical vapor transfer and high energy ball milling methods. In this paper, black phosphorus was successfully synthesized from red phosphorus via chemical vapor transfer and high energy ball milling methods. Then black phosphorus was put in ethanol for 10 min to liquid exfoliation, in which the ultrasonic power was 400 W. The microstructures and stability of black phosphorus synthesized by two methods were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM) and differential scanning calorimeter (DSC). In situ electrical measurements of black phosphorus prepared by chemical vapor transfer were performed using a commercial scanning tunnelling microscope-transmission electron microscope probing system (STM-TEM, Nanofactory Instruments) inserted into a JEOL-2010F TEM. The microstructural characterization results show that there is some red phosphorus and amorphous phases in black phosphorus prepared by high energy ball milling method. On the contrary, the black phosphorus prepared by chemical vapor transfer method has no amorphous phases. The XRD results show that black phosphorus synthesized by chemical vapor transfer method did not change significantly after keeping in the air for 16 days. The DSC results show that the volatile points of the black phosphorus prepared by high energy ball milling and chemical vapor transfer methods are respectively 394.5 and 432.2 degrees C, which means the latter has better thermal stability. The TEM results show that a layer or two layers of phosphorene via liquid exfoliation had been obtained, which is large in size and clean in surface. After being irradiated in TEM with a dose of 0.8 eV/(angstrom(2).s) at 200 kV for 60 min, few new diffraction spots appeared in black phosphorus synthesized by chemical vapor transfer method, which indicates it is relatively stable under electron radiation in vacuum. In a word, the black phosphorus prepared by chemical vapor transfer method has large size, good crystallinity, high purity, and high stability. It can be used to prepare two-dimensional black phosphorus by mechanical exfoliation and liquid exfoliation, and then be applied to advanced microelectronic devices.

Raman Spectroscopy Studies of Black Phosphorus.

Probing The An Isotropic Behaviors Of Black Phosphorus By Transmission Electron Microscopy, Angular-Dependent Raman Spectra, And Electronic Transport Measurements

Study of Black Phosphorus Using Angle-Resolved Polarized Raman Spectroscopy with 442 nm Excitation

Raman Tensor of Layered Black Phosphorus

Strain-induced Modulation on Phonon and Electronic Properties of Suspended Black Phosphorus Field Effect Transistor

Optical Properties of Black Phosphorus

Preparation and Characterization of Black Phosphorus

Cover Feature: Identifying the Crystalline Orientation of Black Phosphorus by Using Optothermal Raman Spectroscopy (chemphyschem 20/2017)

Identifying the Crystalline Orientation of Black Phosphorus Using Angle-Resolved Polarized Raman Spectroscopy.

Raman Tensor of Layered Black Phosphorous

Lattice Vibration and Raman Scattering in Anisotropic Black Phosphorus Crystals

Characterization of Anisotropic Thermal Conductivity of Suspended Nm-Thick Black Phosphorus with Frequency-Resolved Raman Spectroscopy

In-Plane Uniaxial Strain in Black Phosphorus Enables the Identification of Crystalline Orientation.

Anisotropic In-Plane Thermal Conductivity Observed in Few-Layer Black Phosphorus

Electronic Structure of Black Phosphorus Studied by Angle-Resolved Photoemission Spectroscopy

Discerning Black Phosphorus Crystal Orientation and Anisotropy by Polarized Reflectance Measurement.

Investigation of Electronic and Atomic Structure and Transport Properties of Black Phosphorus Single Crystals

Anisotropic Ultraviolet-Plasmon Dispersion In Black Phosphorus

Highly Anisotropic Thermoelectric Properties of Black Phosphorus Crystals

The Study of Crystalline Orientation and Interface Thermal Conductance of Mechanical Exfoliated Black Phosphorus with Raman-based Techniques

Resolving and Tuning Mechanical Anisotropy in Black Phosphorus via Nanomechanical Multimode Resonance Spectromicroscopy