Abstract:Sampling-based PLLs have become a new research trend due to the possibility of removing the frequency divider (FDIV) from the feedback path, where the FDIV increases the contribution of in-band noise by the factor of dividing ratio square (N2). Between two possible sampling methods, sub-sampling and reference-sampling, the latter provides a relatively wide locking range, as the slower input reference signal is sampled with the faster VCO output signal. However, removal of FDIV makes the PLL not feasible to implement fractional-N operation based on varying divider ratios through random sequence generators, such as a Delta-Sigma-Modulator (DSM). To address the above design challenges, we propose a reference-sampling-based calibration-free fractional-N PLL (RSFPLL) with a phase-interpolator-linked sampling clock generator (PSCG). The proposed RSFPLL achieves fractional-N operations through phase-interpolator (PI)-based multi-phase generation instead of a typical frequency divider or digital-to-time converter (DTC). In addition, to alleviate the power burden arising from VCO-rated sampling, a flexible mask window generation method has been used that only passes a few sampling clocks near the point of interest. The prototype PLL system is designed with a 65 nm CMOS process with a chip size of 0.42 mm2. It achieves 322 fs rms jitter, -240.7 dB figure-of-merit (FoM), and -44.06 dBc fractional spurs with 8.17 mW power consumption.

A calibration-free multi-phase sampling Type-II PLL

A Calibration-Free Low Spur Multi-Phase Sampling PLL.

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

A Reference-Sampling Based Calibration-Free Fractional-N PLL with a PI-Linked Sampling Clock Generator

Switched-loop filter for automatically frequency-calibrated phase-locked loops

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

A Quadrature PLL with Phase Mismatch Calibration for 32gs/s Time-Interleaved ADC

A Type-II Dual-Path PLL with Reference-Spur Suppression

A 0.0068 mm~2 Self-calibration Circuit for Phase Locked Loop

A Novel Calibration Technique Applying to an Adaptive-Bandwidth PLL

Digital PLL with Fixed Number of Sampling Points for Repetitive Control Algorithm

Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur

A Low-Power Calibration-Free Fractional-N Digital Pll with High Linear Phase Interpolator

A Fractional- $N$ Sampling PLL with a Merged Constant-Slope DTC and Sampling PD

A 28.8-to-43.2 GHz 79.8 fs$_{\mathrm{rms}}$ Jitter and $-$78.5 dBc Reference Spur PLL Exploiting Complementary Mixing Phase Detector With Mismatch Calibration

Spur-reduction techniques for PLLs using sub-sampling phase detection

A 3.3-4.5GHz Fractional-N Sampling PLL with A Merged Constant Slope DTC and Sampling PD in 40nm CMOS

Spur Reduction Techniques for Phase-Locked Loops Exploiting A Sub-Sampling Phase Detector

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

An Efficient Phase-Locked Loop for Distorted Three-Phase Systems

A Wide-Tuning Quasi-Type-I Pll with Voltage-Mode Frequency Acquisition Aid