Abstract:Modern system-on-chips (SoCs) integrate several independent on-chip clock generators to satisfy diverse specifications for different modules, such as microprocessors, memories, I/O interfaces, and power management. Conventionally, multiple PLLs are used in SoCs to provide various frequency outputs; however, this method incurs a considerable silicon area, power, cost, and the overall system complexity. Fractional output dividers (FODs), which are composed of a multi-modulus divider (MMD), a digital-to-time converter (DTC), and a digital controller, have been proved to be an effective method for multiple independent clock generation. However, the DTC characteristic is PVT sensitive, and any gain mismatch/integral nonlinearity (INL) generates large spurs, which degrade spectral purity and clock jitter. The traditional DTC-gain-calibration algorithm, which is widely applied in PLLs, requires a feedback path to reflect DTC-gain mismatch, which prohibits its use in FODs with the open-loop structure. As shown in the upper left of Fig. 14.2.1, an extra complementary-replica DTC $(\text{DTC}_{\mathrm{c}})$ is adopted to calibrate DTC gain (Kdtc) [1]. However, the replica DTCs consume large power and area while leading to replica-DTC mismatch concerns, which can seriously degrade the calibration effectiveness. Although the extra replica DTC can be removed by capturing the delay of the $\text{DTC}_{\mathrm{M}}$ when the digital control word for DTC (Ddcw) equals to 0 and full code alternatively [2]; unfortunately, this method only makes an effective comparison when delta-sigma modulator (DSM) produces an overflow, resulting in a long calibration-convergence time for some frequency-control words (FCWs). Furthermore, neither of the above solutions takes DTC INL into account; thus, the effectiveness of the spur reduction is limited. Extracting a periodic pattern with digital filters and subtracting it from the input FCW is another approach to reduce FOD spurs [3]. Nevertheless, the calibration effectiveness heavily depends on prior knowledge of spur frequencies and needs complex and onerous preliminary measurements. In order to overcome the above-mentioned issues, this paper presents an FOD with an auxiliary-PLL (aux-PLL)-based background $0^{\text{th}}/1^{\text{st}}/2^{\text{nd}}$ -order DTC-INL-calibration scheme. The aux-PLL functions as a frequency domain filter, which naturally tracks carrier frequency of the input clock. Thus, prior knowledge and foreground calibration are not needed. Compared to the reported -55dBc spur level in [1] and -65dBc spur level in [2], the proposed FOD achieves less than -80dBc worst-case spurious tones, thanks to the proposed aux-PLL -based $0^{\text{th}}/1^{\text{st}}/2^{\text{nd}}$ -order DTC-INL-calibration algorithm.

A Type-II Dual-Path PLL with Reference-Spur Suppression

A High Swing Charge Pump with Current Mismatch Reduction for PLL Applications

A New Type of Charge-Pump Circuit for Low-Voltage High-Speed PLL Application

A 28.8-to-43.2 GHz 79.8 fs$_{\mathrm{rms}}$ Jitter and $-$78.5 dBc Reference Spur PLL Exploiting Complementary Mixing Phase Detector With Mismatch Calibration

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

A 2.1-GHz PLL with -80dBc/-74dBc reference spur based on aperture-phase detector and phase-to-analog converter

Spur-reduction techniques for PLLs using sub-sampling phase detection

A 0.8-V, 2.55-Ghz, 2.62-Mw Charge-Pump PLL with High Spectrum Purity

A 10-to-300mhz Fractional Output Divider with -80Dbc Worst-Case Fractional Spurs Using Auxiliary-PLL-Based Background 0Th/1st/2nd-Order DTC INL Calibration

A calibration-free multi-phase sampling Type-II PLL

A 1.5–2.56-Ghz TDC-Assisted Fast-Locking Wideband Fractional-N CPPLL with Phase Noise of $-$ 138 Dbc/hz at 1-Mhz Offset Frequency

A Dividerless Pll with Low Power and Low Reference Spur by Aperture-Phase Detector and Phase-To-Analog Converter

0.2Mw 70Fsrms-Jitter Injection-Locked PLL Using De-Sensitized SSPD-Based Injecting-Time Self-Alignment Achieving -270Db FoM and -66Dbc Reference Spur

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

A 11.1-to-14.2 GHz Self-adapted Two-point Modulation Dual-path Type-II Digital PLL Concurrently Achieving 124.7-Mhz/μs Chirp Rate and 2.27-Ghz Bandwidth

A Calibration-Free Low Spur Multi-Phase Sampling PLL.

Spur Reduction Techniques for Phase-Locked Loops Exploiting A Sub-Sampling Phase Detector

A 0.4-Ps-jitter −52-Dbc-spur Synthesizable Injection-Locked PLL with Self-Clocked Nonoverlap Update and Slope-Balanced Subsampling BBPD

A low-noise, 0.05–17.8-GHz fractional-N phase-locked loop with two parallel synchronized dual-core voltage-controlled oscillators