Abstract:In the ultra‐high frequency (UHF) technique, the partial discharge inside the power transformer can be localized by the hyperbolic equations. This method is sensitive to the time difference of arrival (TDOA) between the sensors because a small error in the TDOA vector may introduce a considerable localization error. This sensitivity depends on where the UHF sensors are installed on the transformer tank. By properly positioning the UHF sensors on the tank, this sensitivity is reduced. This paper presents a new method to find the best places on the transformer tank for installing the UHF sensors in such a way that the errors in the TDOA vector have the least effect on the localization accuracy. This paper proposes a new method for improving the partial discharge (PD) localization accuracy by detecting the best places of ultra‐high frequency (UHF) sensors on the power transformer tank. In this way, firstly, the critical sites inside the power transformer that can produce PD are determined. Then the sensors' positioning is done in such a way that if the PD happens at each point of these critical sites, the distance between the estimated PD location obtained by solving the time difference of arrival (TDOA) equations and the actual PD location is laid in an acceptable range. For this purpose, the TDOA equations are linearized around the critical PD coordinates as a matrix form A.X = B. The configuration of the sensor positions that minimizes the condition number of the matrix A is the best configuration. To evaluate the effectiveness of the proposed method, several simulations and evaluations are performed on a power transformer in the CST software. The obtained results and comparing them with the previous method and also conventional arbitrary sensors positioning confirm the effectiveness of this method.

UHF Partial Discharge Localization Methodology Based on Generalized Regression Neural Network

Location of PD by Searching in Space Using UHF Method

Partial Discharge Direction of Arrival Estimation in Air-insulated Substation by UHF Wireless Array and RSSI Maximum Likelihood Estimator

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

A Novel Optical Localization Method for Partial Discharge Source Using ANFIS Virtual Sensors and Simulation Fingerprint in GIL

Partial Discharge Inversion Localization Method for GIS Based on Twin Database

Detection and Localization of Partial Discharge in Connectors of Air Power Lines by Means of Ultrasonic Measurements and Artificial Intelligence Models

Partial discharge localisation in transformers using UHF technique: non-iterative method

Ultra‐high frequency sensors positioning on the power transformer to mitigate the negative effects on the partial discharge localization accuracy

An Indoor Unknown Radio Emitter Positioning Approach Using Improved RSSD Location Fingerprinting

Partial Discharge Pattern Recognition Based on an Ensembled Simple Convolutional Neural Network and a Quadratic Support Vector Machine

A Novel Partial Discharge Localization Method for GIL Based on the 3D Optical Signal Irradiance Fingerprint and Bagging‐kelm

Field test on a transformer for partial discharge location by uwb-rf method

An Acoustic Localization Sensor Based on MEMS Microphone Array for Partial Discharge

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Research on Miniaturized UHF Sensing Technology for PD Detection in Power Equipment Based on Symmetric Cut Theory

Partial Discharge Patterns Recognition with Deep Convolutional Neural Networks

Distributed Partial Discharge Locating and Detecting Scheme Based on Optical Fiber Rayleigh Backscattering Light Interference

Passive Wireless Partial Discharge Sensors with Multiple Resonances