Abstract:A wideband full-duplex (FD) receiver with enhanced-linearity technique and shared self-interference cancellation (SIC) is implemented in a 40-nm CMOS process. By combining Hilbert-transform-equalization (HTE)-based self-interference (SI) canceller and translational loop, an FD receiver with RF domain cancellation is presented with an extra auxiliary cancellation path by reusing the mixer in the translational loop. By introducing the auxiliary path, the influence of SI circuit to receiver front end is minimized. Meanwhile, a self-loaded linearization technique with acceptable noise degradation and extra power consumption is proposed to be employed in the FD receiver for both receiver and SI canceller. Due to the 2-D regulation, such a technique can achieve a relatively robust linearity improvement and bring flexibility to circuit design. The measurement results show that the proposed FD receiver operates across 0.8–3.5 GHz with a gain of 29.0–31.8 dB and a noise figure of 3.68–5.23 dB. The proposed linearization technique achieves 3.2–4.7-dB linearity improvement for receiver with only 0.45–0.64-dB NF degradation. In addition, the canceller with the proposed linearization method achieves RF domain delays ranging from 1.59 to 4.03 ns while demonstrating more than 6.33-dB linearity improvement. With the implementation of self-loaded technique and shared SIC, a greater than 23.4-dB RF domain SI suppression is measured across 40-MHz bandwidth (BW) with 64-QAM modulated signals in a circulator-based setup for the SIC scheme in this work with RX noise degradation of less than 1.38 dB.

Design and Implementation of Partial Shared Digital Channelized Receiver

Parallel Processing Design of Multi-channel LIF Digital Receiver

Performance Improvement Of Qo-Stbc Over Time-Selective Channel For Wireless Network

Fractional Spaced Channel Estimation and Shortening for Joint Delayed Decision Feedback Sequence Estimation.

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

The Design And Implement Of A Receiver For Fsk Signal

Design and FPGA Implementation of a Reconfigurable 1024-Channel Channelization Architecture for SDR Application.

Non-equally divided channel receiver based on FPGA

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

Design of an indoor channel measurement system

Design of Parallel Multi-Channel Receiver Based on GC5016

Joint Channel-Estimation/Decoding with Frequency-Selective Channels and Few-Bit ADCs

FPGA Implementation of a Reconfigurable Channelization for Simultaneous Multichannel DRM30/FM Receiver.

Receiver Design in Full-Duplex Joint Radar-Communication Systems

RF Chain Reduction for MIMO Systems: A Hardware Prototype

A Novel Receiver Design with Joint Coherent and Non-Coherent Processing

RF Channelizer Architectures Using Iterative Downconversion for Concurrent or Fast-Switching Spectrum Analysis

Robust Hybrid Precoding/Combining Designs for Full-Duplex Millimeter Wave Relay Systems

A Receiver Structure Of Joint Ldpc Decoding And Synchronization For Deep Space Communications

A New Architecture of UHF RFID Digital Receiver for SoC Implementation

Enhanced-Linearity Wideband Full-Duplex Receiver With Shared Self-Interference Canceller