Abstract:Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing capacity demands. Full-duplex technology can further enhance the advantages of mmWave massive MIMO systems. However, strong self-interference (SI) is the major limiting factor in full-duplex technology. Hence, this paper proposes a novel angular-based joint hybrid precoding/combining (AB-JHPC) technique for the full-duplex mmWave massive-MIMO systems. Our primary goals are listed as: (i) improving the self-interference cancellation (SIC), (ii) increasing the intended signal power, (iii) decreasing the channel estimation overhead, (iv) designing the massive MIMO systems with a low number of RF chains. First, the RF-stage of AB-JHPC is developed via slow time-varying angle-of-departure (AoD) and angle-of-arrival (AoA) information. A joint transmit/receive RF beamformer design is proposed for covering (excluding) the AoD/AoA support of intended (SI) channel. Second, the BB-stage of AB-JHPC is constructed via the reduced-size effective intended channel. After using the well-known singular value decomposition(SVD) approach at the BB-stage, we also propose a new semi-blind minimum mean square error (S-MMSE) technique to further suppress the residual SI power by using AoD/AoA parameters. The numerical results demonstrate that the SI signal is remarkably canceled via the proposed AB-JHPC technique. It is shown that AB-JHPC achieves 85.7 dB SIC and the total amount of SIC almost linearly increases via antenna isolation techniques. We observe that the proposed full-duplex mmWave massive MIMO systems double the achievable rate capacity compared to its half-duplex counterpart as the antenna array size increases and the transmit/receive antenna isolation improves.

Robust Hybrid Precoding/Combining Designs for Full-Duplex Millimeter Wave Relay Systems

Two-Timescale Hybrid Analog-Digital Beamforming for Mmwave Full-Duplex MIMO Multiple-Relay Aided Systems

A Hybrid Beamforming Receiver with Two-Stage Analog Combining and Low-Resolution ADCs

Robust Joint Hybrid Transceiver Design for Millimeter Wave Full-Duplex MIMO Relay Systems

Precoding Design for Full-Duplex Transmission in Millimeter Wave Relay Backhaul.

Low-Complexity Hybrid Precoding Design For Mimo-Ofdm Millimeter Wave Communications

Hybrid Precoder and Combiner Design with Low Resolution Phase Shifters in mmWave MIMO Systems

Precoder Design for MIMO Decode-and-forward Relay Channels with Energy Harvesting Constraint

Hybrid Beamforming for Millimeter Wave Full-Duplex under Limited Receive Dynamic Range

Hybrid Analog-Digital Beamforming for Multiuser MIMO Millimeter Wave Relay Systems

MIMO-Aided Nonlinear Hybrid Transceiver Design for Multiuser Mmwave Systems Relying on Tomlinson-Harashima Precoding

Low-complexity hybrid precoding for sub-connected millimeter wave massive MIMO systems

Hybrid Precoder Design for Millimeter Wave Systems Based on Geometric Construction.

On Precoding and Energy Efficiency of Full-Duplex Millimeter-Wave Relays.

Full-Duplex mmWave Massive MIMO Systems: A Joint Hybrid Precoding/Combining and Self-Interference Cancellation Design

Robust Joint Hybrid Analog-Digital Transceiver Design for Full-Duplex Mmwave Multicell Systems.

Robust Transceiver Design for Full-Duplex MIMO Relay Systems.

Hybrid Precoding and Combining for mmWave Full-Duplex Joint Radar and Communication Systems under Self-Interference

A Family of Hybrid Precoding Schemes for Millimeter-Wave Massive MIMO Systems

Reconfigurable Intelligent Surface-Aided Full-Duplex mmWave MIMO: Channel Estimation, Passive and Hybrid Beamforming

Linear Precoding Designs for Amplify-and-Forward Multiuser Two-Way Relay Systems.