Hybrid Precoder and Combiner Design with Low Resolution Phase Shifters in mmWave MIMO Systems

Zihuan Wang,Ming Li,Qian Liu,A. Lee Swindlehurst

DOI: https://doi.org/10.1109/JSTSP.2018.2819129

2017-10-17

Abstract:Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless networks. Economical and energy efficient analog/digial hybrid precoding and combining transceivers have been often proposed for mmWave massive multiple-input multiple-output (MIMO) systems to overcome the severe propagation loss of mmWave channels. One major shortcoming of existing solutions lies in the assumption of infinite or high-resolution phase shifters (PSs) to realize the analog beamformers. However, low-resolution PSs are typically adopted in practice to reduce the hardware cost and power consumption. Motivated by this fact, in this paper, we investigate the practical design of hybrid precoders and combiners with low-resolution PSs in mmWave MIMO systems. In particular, we propose an iterative algorithm which successively designs the low-resolution analog precoder and combiner pair for each data stream, aiming at conditionally maximizing the spectral efficiency. Then, the digital precoder and combiner are computed based on the obtained effective baseband channel to further enhance the spectral efficiency. In an effort to achieve an even more hardware-efficient large antenna array, we also investigate the design of hybrid beamformers with one-bit resolution (binary) PSs, and present a novel binary analog precoder and combiner optimization algorithm with quadratic complexity in the number of antennas. The proposed low-resolution hybrid beamforming design is further extended to multiuser MIMO communication systems. Simulation results demonstrate the performance advantages of the proposed algorithms compared to existing low-resolution hybrid beamforming designs, particularly for the one-bit resolution PS scenario.

Information Theory

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to design hybrid precoders and combiners for low - resolution phase shifters applicable to millimeter - wave (mmWave) large - scale multiple - input multiple - output (MIMO) systems. Specifically, the paper focuses on how to achieve efficient hybrid precoding and combining techniques using low - resolution (especially 1 - bit resolution) phase shifters under the condition of low hardware cost and power consumption, in order to overcome the severe path loss in millimeter - wave communication and maximize the spectral efficiency.

### Main Problems

1. **Limitations of High - Resolution Phase Shifters**:
- Existing hybrid precoding and combining schemes usually assume the use of infinite or high - resolution phase shifters to achieve analog beamforming. However, in practical applications, low - resolution phase shifters are usually adopted in order to reduce cost and power consumption.
- High - resolution phase shifters will significantly increase the hardware complexity and energy consumption, so they are not suitable for practical millimeter - wave systems.

2. **Design Challenges of Low - Resolution Phase Shifters**:
- Low - resolution phase shifters will lead to a decline in beamforming accuracy, thus affecting the performance of the system.
- It is necessary to design an algorithm that can maximize the spectral efficiency under the condition of low - resolution phase shifters.

### Solutions

1. **Iterative Algorithm Design**:
- The paper proposes an iterative algorithm to design pairs of low - resolution analog precoders and combiners for each data stream in turn, with the goal of maximizing the spectral efficiency under given conditions.
- By introducing an interference - inclusive effective channel matrix \( \mathbf{Q}_l \), the optimization problem is decomposed into multiple sub - problems to design the precoder and combiner for each data stream respectively.

2. **Design of 1 - Bit Resolution Phase Shifters**:
- For 1 - bit resolution phase shifters, the paper proposes an efficient optimization algorithm based on rank - 1 approximation.
- By decomposing the joint optimization problem into problems of separately designing the precoder and combiner, the computational complexity is further reduced.
- Using the methods of auxiliary variables and candidate sets, the optimal solution can be found with linear complexity while ensuring performance.

### Specific Steps

1. **Design of Low - Resolution Analog Precoder and Combiner**:
- Use singular value decomposition (SVD) to decompose the channel matrix \( \mathbf{H} \) into \( \mathbf{H}=\mathbf{U} \mathbf{\Sigma} \mathbf{V}^H \).
- Define the interference - inclusive effective channel matrix \( \mathbf{Q}_l \).
- Through the iterative phase - matching algorithm, gradually optimize the phases of the precoder and combiner for each data stream.

2. **Design of Digital Precoder and Combiner**:
- After determining all pairs of analog precoders and combiners, calculate the effective baseband channel \( \tilde{\mathbf{H}} \).
- Use the SVD method to design the baseband digital precoder and combiner to further improve the spectral efficiency.

3. **Design of 1 - Bit Resolution Phase Shifters**:
- Simplify the optimization problem through rank - 1 approximation.
- Construct a candidate set to find the optimal 1 - bit precoder and combiner with linear complexity.

### Summary

This paper successfully solves the problem of designing efficient hybrid precoders and combiners under the condition of low - resolution phase shifters by proposing an iterative algorithm and an optimization method based on rank - 1 approximation. These methods are not only innovative in theory, but also can significantly reduce hardware cost and power consumption in practical applications while maintaining high system performance.