Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

Design of Parallel Multi-Channel Receiver Based on GC5016

Parallel Processing Design of Multi-channel LIF Digital Receiver

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

The Design And Implement Of A Receiver For Fsk Signal

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A New Receiver Structure of TT&C Transponder for Pico-Satellite

A Design Method of Channelized Receiver Based on Poly-Phase Filter Banks

A parallel ADC structure for software radio receiver

Design of General Ground Integrated Test Intermediate Frequency Receiver for Satellite Transmission System (in Chinese)

Design of A Parallel Low Power Flash A/D Converter for the Sub-Sampling Ir-Uwb Receiver

Parametric Design of RS Decoding Module in HDTV

The Research And Simulation Of Synchronization Algorithms Of Gbps Parallel Digital Receiver

Architecture of Prototype Galileo User Receiver Based on DDS Technique

Design and Application of a High Rate Digital Receiver Using TDA 8044 Demodulation Chip

Design and Implementation of Partial Shared Digital Channelized Receiver

Research of Fully Integrated CMOS SCA Receiver

The design of software radio receiver

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

All-digital Sub-sampling Architecture for an Impulse Radio Ultra Wideband Receiver

Design of 4-bit parallel sub-sampling A/D converter for IR-UWB receiver.