Abstract:Flanging of pipe fittings is widely used in the industrial field. Flanging die is used in the traditional process, which has poor flexibility and high cost. Progressive forming is a process for forming tubular parts developed in recent years. A multi-pass progressive flanging process of round metal tube ends with ball-end tool bar as the forming tool is introduced, and dieless flanging of tubes can be realized by means of numerical control machine. Based on the process of multi-pass progressive flanging of round tubes, an analytical model of the forming force (axial, radial, and tangential) is established by taking the micro-element contacting tool bar with tube as the research object. Additionally, numerical simulation with the commercial ABAQUS is conducted complementarily to reveal the stress and strain evolution during the flanging process. An experimental work is conducted to investigate the forming force of the flange process of copper tubes. A comparison between forming loads analytically and experimentally is discussed; the mechanism of the flanging force in the multi-pass progressive flanging process of metal tube end is studied. The radial and axial forces in the forming process are related to the current flanging angle and the angle increment of each pass. When the flanging angle is greater than 30°–40°, the axial forming force becomes the largest, followed by the radial forming force. The comparison indicates that error between the radial forming force obtained by theory and simulation and by experiment is within 5%, and that of the axial forming force is less than 20%. Moreover, the flange thinning is discussed. The results show that the flanging flange is thinned evenly in the middle region, outermost edge of flange is thinned seriously, and the thinning rate is about 48%.

Process Parameters of Flexible Flanging

Knowledge Based Design Support System for Complex Flanging Process Planning

Study on the influences of geometrical parameters on the formability of stretch curved flanging by numerical simulation

Parameters Optimization of Tailor Welded Blank Forming Process

The Numerical and Analytical Study on Stretch Flanging of V-Shaped Sheet Metal

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Research on Toolpath Optimization of Robot-Assisted Incremental Flanging

Modeling and analysis of multi-pass progressive flanging force of copper tube end

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Deformation Mechanics and Failure Mode in Stretch and Shrink Flanging by Double-Sided Incremental Forming

Analytical and Numerical Study on Flanging of Curved Sheet Metal Part

Deformation analysis and die-design principles in shrink curved flanging

Experimental investigations on the forming mechanism of a new incremental stretch-flanging strategy with a featured tool

Study on the forming process of the crossmember in car intermediate floor

FE analysis of the flat surface-straight edge hemming process

Numerical Study on Flanging of V-Shaped Sheet Metal Part

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Influence of Cutting Process on the Flanging Formability of the Cut Edge for DP980 Steel

The flexible rolling process of three-dimensional curved parts using an auxiliary plate based on rigid arc-shaped rollers

Numerical Simulation of Double Rollers Clamping Spinning Process for Flanging