Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Study on the influences of geometrical parameters on the formability of stretch curved flanging by numerical simulation

The Numerical and Analytical Study on Stretch Flanging of V-Shaped Sheet Metal

Process Parameters of Flexible Flanging

Numerical Study on Flanging of V-Shaped Sheet Metal Part

Analytical and Numerical Study on Flanging of Curved Sheet Metal Part

Study on the forming process of the crossmember in car intermediate floor

Numerical study on forming limit curve in sheet stamping and tube hydroforming

Investigation of Sheet Metal Forming by Numerical Simulation and Experiment

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process

Deformation Mechanics and Failure Mode in Stretch and Shrink Flanging by Double-Sided Incremental Forming

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Numerical Simulation And Experimental Method For Auto-Panel Forming Defects Analysis

Numerical Simulation and Parameter Optimization in Forming Process of an Automobile Squab Panel

Deformation analysis and die-design principles in shrink curved flanging

Investigation on Forming Process of Automobile Trunk Side Panel Based on Numerical Simulation Technology

Study on the Formability and Its Geometric Factors of Seamed Tube Hydroforming

Experimental investigations on the forming mechanism of a new incremental stretch-flanging strategy with a featured tool

FE analysis of the flat surface-straight edge hemming process

Application of Forming Simulation of Automobile Covering Parts

Sheet metal forming limits under stretch-bending with anisotropic hardening

Numerical Simulation Research on Hydroforming Process of Automobile Front Transom