Abstract:Friction stir welding (FSW), as a solid state joining technique, has emerged as an efficient method for manufacturing tailor-welded blanks to optimize weight or performance in the final component. As the basic design of lightweight frame structures in the automotive and aircraft industry is frequently based on tubular profiles, the joining strategies and forming technologies have to be developed accordingly. In the present study, FSW tube was produced by a novel processing sequence. The plastic deformation characteristics during hydroforming were experimentally and numerically investigated with two types of end condition. The hydroforming performance of the FSW tubes was mainly investigated by die-bulge forming with fixed ends, and the wrinkling behavior during hydroforming was analyzed by employing axial feed on the tube ends. It is found that hydroforming FSW tube is a new deal and does show a few peculiarities. The FSW tube exhibits a spiral weld and the basin-shaped nugget. Fine-grained structure is retained during tube forming. The thinning of the tube in axial direction shows M-shaped distribution during hydroforming. The severe thinning is observed at one quarter of the expansion zone from symmetry plane. In the hoop direction, the base material near the weld suffers severe thinning due to the high hoop and axial tensile stress. The thickness distribution greatly depends on the sequence of the contacting die and the variations of the curvature radius of the tube during hydroforming. Moreover, the weld shows an inhibitory effect for the generation of the wrinkles and decreases the number of the wrinkles as compared to the seamless tube during hydroforming. This effect is more obvious when the forming pressure is lower.

Study on the Formability and Its Geometric Factors of Seamed Tube Hydroforming

Numerical study on forming limit curve in sheet stamping and tube hydroforming

Theoretical and Experimental Study on Formability of Laser Seamed Tube Hydroforming

Prediction of Forming Limit Diagram for Seamed Tube Hydroforming Based on Thickness Gradient Criterion

A Theoretical and Experimental Study on Forming Limit Diagram for A Seamed Tube Hydroforming

Study on Experimental Approaches of Forming Limit Curve for Tube Hydroforming

Study on Formability of Tube Hydroforming Through Elliptical Die Inserts

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Effect of the Load Path on Formability of T-Shaped Tube Hydroforming

Effect of the process parameters on T-shaped tube hydroforming

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

Numerical Analysis for Forming Limit of Welded Tube in Hydroforming

Study on the Crushing and Hydroforming Processes of Tubes in a Trapezoid-Sectional Die

Experimental Study on Forming Limit Diagram of Laser Welded Tube Hydroforming

Effects of preform on thickness distribution of hydroformed Y-shaped tube

The Determination of Mechanical Properties of Seamed Tube with Hydraulic Bulge Test

Experimental and Numerical Study on Hydroforming Characteristics of Friction Stir Welded Aluminum Alloy Tubes

Practicality and Formability of Integrally Stiffened Tube Hydro-Assisted Forming

Three-dimensional forming limit diagram for fluid pressure forming of tubes

Research on Hydroforming Tubular Part with Large Perimeter Difference

Analysis and experiment on tube hydroforming in a rectangular cross-sectional die