Abstract:Loop heat pipe (LHP) is widely used to solve the problem of high heat flux in electronic chips due to its excellent heat transfer efficiency, good thermal equilibrium, and large heat transfer limit. To further improve the heat transfer efficiency of the LHP, a novel LHP was designed with a parallel arrangement of 13 vapor channels (2 mm × 2 mm) capillary wick structure. Experimental investigations were conducted to evaluate the start-up and steady-state performance of the LHP under both regular and random variable loads ranging from 30 W to 180 W. The findings indicate that the LHP exhibits rapid start-up and operates smoothly within the heat load range of 30 W–180 W, maintaining the heat source temperature below 75 °C, thereby meeting the temperature requirements for chip operation.Under a regular variable heat load, the LHP experiences minimal temperature fluctuations, but the system operated with good stability. Meanwhile, under random variable heat loads, the LHP demonstrates quick responsiveness within 5 s and reaches a stable state within 8 min. The temperature fluctuations remain within 2 °C, effectively fulfilling the temperature control demands of electronic devices. Furthermore, the evaporator thermal resistance, condenser thermal resistance, loop thermal resistance and system thermal resistance of the LHP gradually decrease with increasing of heat load. When reaching a heat load of 180 W, the evaporator thermal resistance (Re ), condenser thermal resistance (Rc ), loop thermal resistance (RLHP ), and system thermal resistance (Rsys ) reach their minimum, with values of 0.0168 °C/W, 0.121 °C/W,0.137 °C/W and 0.229 °C/W, respectively. In comparison with other LHPs, the evaporator temperature was only 59.56 °C with the highest heat load of 210 W (52.5 W/cm2), which expanded the application range of the LHP for electronic devices cooling.

Experimental Study on a R134a Loop Heat Pipe with High Heat Transfer Capacity

Partial Visualization Study on Flow, Startup and Heat Transfer Characteristics of Closed-Loop Pulsating Heat Pipe with R1336mzz(Z)

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

A Study on Thermal Performance of a Pump-Assisted Loop Heat Pipe with Ammonia As Working Fluid

Advanced loop heat pipe application for cooling high power LED lights

Experimental Study of a Novel Loop Heat Pipe with a Vapor-Driven Jet Injector and a Boiling Pool

Experimental studies on a high performance compact loop heat pipe with a square flat evaporator

Experimental Study on a Pump Driven Loop-Heat Pipe for Data Center Cooling

Investigation of a Gas-Pump-Driven Loop Heat Pipe

Experimental Investigation Thermal Performance of Loop Heat Pipe Operating with Different Working Fluids

Experimental study of flat-disk loop heat pipe with R1233zd(E) for cooling terrestrial electronics

Experimental Research on the Heat Performance of a Flat Copper-Water Loop Heat Pipe with Different Inventories

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Experimental Study on Loop Heat Pipe with Flat Evaporator at Different Tilt Angles

Experimental investigation on a flat loop heat pipe coupled with thermoelectric cooler

Application Research for Pump-driven Loop Heat Pipe System Using R32 to Replace R22

Experimental research on boiling heat transfer mechanism of a pump-driven loop thermosiphon for R134a coolant

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental investigation for the loop heat pipe with a bifacial flat evaporator