Abstract:A micromixer is one of the most significant components in a microfluidic system. A three-dimensional micromixer was developed with advantages of high efficiency, simple fabrication, easy integration, and ease of mass production. The designed principle is based on the concepts of splitting–recombination and chaotic advection. A numerical model of this micromixer was established to characterize the mixing performance for different parameters. A critical Reynolds number (Re) was obtained from the simulation results. When the Re number is smaller than the critical value, the fluid mixing is mainly dependent on the mechanism of splitting–recombination, therefore, the length of the channel capable of complete mixing (complete mixing length) increases as the Re number increases. When the Re number is larger than the critical value, the fluid mixing is dominated by chaotic advection, and the complete mixing length decreases as the Re number increases. For normal fluids, a complete mixing length of 500 µm can be achieved at a very small Re number of 0.007 and increases to 2400 µm as the Re number increases to the critical value of 4.7. As the Re number keep increasing and passes the critical Re number, the complete mixing length continues to descend to 650 µm at the Re number of 66.7. For hard-to-mix fluids (generally referring to fluids with high viscosity and low diffusion coefficient, which are difficult to mix), even though no evidence of strong chaotic advection is presented in the simulation, the micromixer can still achieve a complete mixing length of 2550 µm. The mixing performance of the micromixer was also verified by experiments. The experimental results showed a consistent trend with the numerical simulation results, which both climb upward when the Re number is around 0.007 (flow rate of 0.03 μm/min) to around 10 (flow rate of 50 μm/min), then descend when the Re number is around 13.3 (flow rate of 60 µm/min).

Design and Evaluation of Three-Dimensional Zigzag Chaotic Micromixers for Biochemical Applications

Staggered Oriented Ridges Micromixer Based on Chaotic Advection

Realization of planar mixing by chaotic velocity in microfluidics

Design and Evaluation of an Easily Fabricated Micromixer with Three-Dimensional Periodic Perturbation

Design, Implementation, and Optimization of a Novel Chaotic Micromixer

A “twisted” Microfluidic Mixer Suitable for a Wide Range of Flow Rate Applications

Numerical Simulation on Fluid Mixing by Effects of Geometry in Staggered Oriented Ridges Micromixers

3D Printed Chaotic Mixer for Low Reynolds Number Microfluidics

Design and Experimental Study of Staggered Oriented Ridges Micromixers

Influence Of Geometric Configuration On Mixing Performance Of Planar Chaotic Micro-Mixer

Influence of Structural Parameters on the Performance of an Asymmetric Rhombus Micromixer with Baffles

Performance analysis of combined zigzag and curved micromixers

Numerical study of a novel electroosmotic active micromixer with twin diamond-shaped chambers and sawteeth

An Investigation of Chaotic Mixing Behavior in a Planar Microfluidic Mixer

A compact and efficient three-dimensional microfluidic mixer

A Three-Dimensional Double-Helical Structure Microfluidic Chip with Efficient Mixing

Design and Simulation of a Passive Micromixer with Gourd-Shaped Channel.

Design and Analysis of a Chaotic Micromixer with Vortices Modulation

Novel Micromixer with Complex 3D-Shape Inner Units: Design, Simulation and Additive Manufacturing

A Three-Dimensional Micromixer Using Oblique Embedded Ridges

A Novel Passive Three-Dimensional Asymmetric Arc Micromixer Based On The Concept Of Chaotic Advection And Unbalanced Splitting-Collision