Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

A 3.5-Ghz 0.24-Nj/b 100-Mb/s Fully Balanced FSK Receiver with Sideband Energy Detection

The Design And Implement Of A Receiver For Fsk Signal

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A 0.14-nJ/b 200-Mb/s 2.7–3.5-GHz Quasi-Balanced FSK Transceiver With PLL-Based Modulation and Sideband Energy Detection

A 0.14nj/b 200mb/s Quasi-Balanced FSK Transceiver with Closed-Loop Modulation and Sideband Energy Detection

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 60ghz BiCMOS Self-Demodulator with Injection Locked Oscillator

A 3.7-Mw 2.4-Ghz Phase-Tracking GFSK Receiver with BBPLL-Based Demodulation.

2.4Ghz 20mb/s FSK Receiver Front-End and Transmitter Modulation PLL Design for Energy-Efficient Short-Range Communicaiton

A 1.9-Mw 750-Kb/s 2.4-Ghz F-OOK Transmitter with Symmetric FM Template and High-Point Modulation PLL.

A 6.1mW 5Mb/s 2.4GHz transceiver with F-OOK modulation for high bandwidth and energy efficiencies

A 164-$\mu$ W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications

A 100Mb/s 3.5GHz Fully-Balanced BFOOK Modulator Based on Integer-N Hyrbrid PLL

A 164-W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications

A 2.4-Ghz Crystal-Less GFSK Receiver Using an Auxiliary Multiphase BBPLL for Digital Output Demodulation with Enhanced Frequency Scaling

A 0.45 pJ/b 24 Gb/s NRZ Receiver Data-Path Using Half-Baud-Rate Duobinary Sampling

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.