Abstract:The underground energy geostructure represented by the energy pile is one of the key paths for the cooperative development of underground space and geothermal energy. Because of its advantages of low cost, high efficiency and no extra occupation of underground space, it has become a feasible alternative to the borehole heat exchanger. The change in the temperature field of the energy pile and its surrounding ground not only affects the geological environment but also influences the thermomechanical performance and the durability of the structure. However, the temporal and spatial unsteady-state temperature distribution of piles and surrounding rock under typical intermittent and unbalanced thermal load conditions is still unclear. In this paper, a finite element model was applied to analyze the unsteady-state temperature distribution, and the thermomechanical behavior of the energy pile group was developed and verified. The temperature field distribution of pile and surrounding rock under typical intermittent working and unbalanced thermal load conditions were determined. Moreover, the thermomechanical behavior characteristics of the energy pile group were investigated. Finally, the influences of pile layout on the thermomechanical behavior of the energy pile group were identified by designing six different scenarios. The results indicate that under typical intermittent operation conditions, the temperature of the energy pile and surrounding ground near the heat exchange pipe varies periodically. For areas with unbalanced cooling and heating loads, long-term operation of energy piles leads to thermal accumulation, and the maximum temperature of energy piles occurs in the first daily cycle. In summer/winter working conditions, the increase/decrease in pile temperature induces axial compression/tensile stress. When the pile group is partially used as the energy pile, the non-energy pile acts as the “anchor pile”, and it generates the added tensile stress.

Finite Element Analyses of Bearing Performance of Energy Pile Based on TTS Model

Dynamic torsional response of an end bearing pile in saturated poroelastic medium

Dynamic torsional response of an end bearing pile in transversely isotropic saturated soil

Study on torsional vibration of pile embedded in saturated soil

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile

FEM Analysis and Simplified Approach for a Single Energy Pile Subjected to Thermomechanical Loads

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Bearing Performance of Geothermal Energy Pile Subjected to Thermal Loading

An Elasto-Plastic Numerical Analysis of THM Responses of Floating Energy Pile Foundations Subjected to Asymmetrical Thermal Cycles

Influence of Thermal Loading on Bearing Capacity of Geothermal Energy Piles

A Finite Element Model for Investigating Unsteady-State Temperature Distribution and Thermomechanical Behavior of Underground Energy Piles

A New Method for Analyzing the Thermomechanical Behavior and the Null Point Movement of Energy Piles

A Study on the Softening Shear Model of the Energy Pile–Soil Contact Surface

Dynamic Impedances and Free-Field Vibration Analysis of Pile Groups in Saturated Ground

The performance analysis of energy piles in cross-anisotropic soils

Behavior analysis of energy piles in layered transversely isotropic saturated soils

Model Test And Numerical Analysis Of Geogrid-Reinforced Pile-Supported Foundation

Analytical solutions for thermal–mechanical coupling of energy piles in double-layer soil

Bearing characteristic of static drill rooted pile considering condition of energy carrier