Preparation of Bisphenol A Polyaryl Ether Nitrile Microporous Foam

Qing Qi,Yajie Lei,Xiaobo Liu

DOI: https://doi.org/10.1088/1755-1315/781/5/052016

2021-01-01

IOP Conference Series Earth and Environmental Science

Abstract:Different foam structure of bisphenol A polyarylene ether nitrile (BPA-PEN) foams were prepared by supercritical carbon dioxide foaming method. First, BPA-PEN films obtained by solution casting method. The properties of BPA-PEN films and foams were characterized by scanning electron microscope (SEM), infrared spectrometer (FTIR), thermogravimetric analysis (TGA) and tensile test. The cell morphology of BPA-PEN foams with different adsorption pressure and foaming time have been investigated. The foaming temperature and saturation pressure have a great influence on the cell size and cell density of BPA-PEN foams. As the foaming temperature increases, when the foaming temperature is closer to the optimal foaming temperature, the viscosity of the BPA-PEN/CO2 homogeneous system become lower, which promotes the diffusion rate of CO2 in BPA-PEN and promotes the growth of bubbles. At the same time, the plasticizing effect of gas reduces the glass transition temperature of BPA-PEN/CO2. The best foaming temperature of BPA-PEN is 150 °C. When the foaming temperature exceeds the optimal foaming temperature, the cell density decreases, the cell wall becomes thicker, and the cell distribution becomes uneven. The mechanical properties of BPA-PEN changed significantly before and after foaming.