Abstract:Emissions tests were conducted on two medium heavy-duty diesel trucks equipped with a particulate filter (DPF), with one vehicle using a NOx absorber and the other a selective catalytic reduction (SCR) system for control of nitrogen oxides (NOx). Both vehicles were tested with two different fuels (ultra-low-sulfur diesel [ULSD] and biodiesel [B20]) and ambient temperatures (70ºF and 20ºF), while the truck with the NOx absorber was also operated at two loads (a heavy weight and a light weight). The test procedure included three driving cycles, a cold start with low transients (CSLT), the federal heavy-duty urban dynamometer driving schedule (UDDS), and a warm start with low transients (WSLT). Particulate matter (PM) emissions were measured second-by-second using an Aethalometer for black carbon (BC) concentrations and an engine exhaust particle sizer (EEPS) for particle count measurements between 5.6 and 560 nm. The DPF/NOx absorber vehicle experienced increased BC and particle number concentrations during cold starts under cold ambient conditions, with concentrations two to three times higher than under warm starts at higher ambient temperatures. The average particle count for the UDDS showed an opposite trend, with an approximately 27% decrease when ambient temperatures decreased from 70ºF to 20ºF. This vehicle experienced decreased emissions when going from ULSD to B20. The DPF/SCR vehicle tested had much lower emissions, with many of the BC and particle number measurements below detectable limits. However, both vehicles did experience elevated emissions caused by DPF regeneration. All regeneration events occurred during the UDDS cycle. Slight increases in emissions were measured during the WSLT cycles after the regeneration. However, the day after a regeneration occurred, both vehicles showed significant increases in particle number and BC for the CSLT drive cycle, with increases from 93 to 1380% for PM number emissions compared with tests following a day with no regeneration. Implications: The use of diesel particulate filters (DPFs) on trucks is becoming more common throughout the world. Understanding how DPFs affect air pollution emissions under varying operating conditions will be critical in implementing effective air quality standards. This study evaluated particulate matter (PM) and black carbon (BC) emissions with two DPF-equipped heavy-duty diesel trucks operating on conventional fuel and a biodiesel fuel blend at varying ambient temperatures, loads, and drive cycles.

Emission Characteristic of Non-Road Mobile Machinery Using a Catalysed Diesel Particle Filter with Different Catalyst Loadings under Actual Operating Conditions

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

Effect of catalyst diesel particulate filter aging and catalyst loadings on particulate emission characteristics from a diesel vehicle

Gas Emissions and Particulate Matter of Non-Road Diesel Engine Fueled with F-T Diesel with EGR

Study on Emission Characteristics and Emission Reduction Effect for Construction Machinery under Actual Operating Conditions Using a Portable Emission Measurement System (Pems)

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Impacts of Continuously Regenerating Trap and Particle Oxidation Catalyst on the NO2 and Particulate Matter Emissions Emitted from Diesel Engine.

Fuel Consumption and Emission Reduction for Non-Road Diesel Engines with Electrically Heated Catalysts

Study on Exhaust Emission Test of Diesel Vehicles Based on PEMS

Study of the Influence of Methanol/f-T Diesel Combustion Particle Materiality Parameters on the Deposition Process in Diesel Particulate Filter Trap Units

An experimental investigation of particle and NOx emissions for a non-road diesel engine equipped with an integrated DOC + CDPF + SCR aftertreatment system during different operations

Characterizing Particulate Polycyclic Aromatic Hydrocarbon Emissions from Diesel Vehicles Using a Portable Emissions Measurement System

Experimental investigation on the effects of DPF Cs-V-based non-precious metal catalysts and their coating forms on non-road diesel engine emission characteristics

Condensable and filterable particulate matter emitted from typical diesel vehicles in steady and transient driving conditions

Technical note: Emission factors, chemical composition, and morphology of particles emitted from Euro 5 diesel and gasoline light-duty vehicles during transient cycles

Exploring ultrafine particle emission characteristics from in-use light-duty diesel trucks in China using a portable measurement system

Filtration Efficiency and Regeneration Behavior in a Catalytic Diesel Particulate Filter with the Use of Diesel/Polyoxymethylene Dimethyl Ether Mixture

Temperature effects on particulate emissions from DPF-equipped diesel trucks operating on conventional and biodiesel fuels

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Characterization of Gas and Particulate Phase Organic Emissions (C 9 -C 37 ) from a Diesel Engine and the Effect of Abatement Devices.

Particle Size Distributions and OC, EC Emissions from a Diesel Engine with the Application of In-Cylinder Emission Control Strategies