Abstract:Programmable active bandpass filters (BPFs) have been designed in a chip-scale heterogeneous integration technology, which intimately integrates InP HBTs on a deep scaled CMOS technology. Therefore, the active BPF can leverage both high performance of InP HBT and high density and programmability of CMOS. Two BPF prototypes, consisting of a programmable gain amplifier (PGA), a fifth- or third-order BPF core, and a buffer, have been designed and fabricated. The BPF center frequency can be switched from 0.8 to 2.2 GHz with 150-MHz passband and delivers > 55-dB out-of-band (OOB) rejection for the fifth-order one. Four gain steps: 0, 6, 12, and 16 dB, are enabled by the front PGA to trade off noise and linearity performances. Due to the > 300-GHz f T of InP HBTs, the BPF cores can leverage active-RC architecture for high linearity owing to the close-loop implementation. The fifth-order BPF prototype occupies a 1.5 × 1.02 mm2 area together with pads and draws 106/121 mA from a 3.3-V power supply for 0.8/2.2-GHz bands, respectively, which demonstrates OOB output third-order intercept points (OIP3s) of 22.69/21.25 dBm for 0.8/2.2-GHz bands at the high gain mode. The measurement results suggest the fifth-order BPF core achieves 36.69/35.25-dBm OOB OIP3s. In addition, the designed third-order programmable BPF has been successfully used as a technology yield vehicle to assist the BiCMOS technology development.

An 4 Th -Order N-path Bandpass Filter with a Tuning Range of 1-30 GHz and OOB Rejection > 30 Db in 28 Nm CMOS

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

0.8/2.2-GHz Programmable Active Bandpass Filters in InP/Si BiCMOS Technology

A 0.8/2.4 GHz Tunable Active Band Pass Filter in InP/Si BiCMOS Technology

A Novel 76 and 94ghz Dual Band Bandpass Filter Using Multilayer Step Impedance Resonators (Sirs)

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

The design and test of dual/triple-mode bandpass filter based on temporal coupled-mode theory

A high selectivity, low insertion loss 60GHz-band on-chip 4-pole band pass filter for millimeter wave CMOS SoC

An N-Path Filter Design Methodology With Harmonic Rejection, Power Reduction, Foldback Elimination, and Spectrum Shaping

Cost-efficient CMOS RF Tunable Bandpass Filter with Active Inductor-Less Biquads

A 5.4-Mw 50-Mhz 29.3-Dbm-iip3 Fourth-Order Low-Pass Filter

A 5.7mw +30dbm IIP3, Tunable Active-RC LPF in 40nm CMOS

A 0.6mw 31mhz 4Th-Order Low-Pass Filter with +29dbm IIP3 Using Self-Coupled Source Follower Based Biquads in 0.18µm CMOS

A 0.5&#x2013;2 GHz High Frequency Selectivity RF Front-End with Series N-path Filter

A 2.2–3.6 GHz CMOS Reconfigurable Fourth-Order Bandpass Filter With Compact Size and High Selectivity Using Transformer-Type Resonators

A Wide Tuning Range Low-Pass Gm-C Filter for Multi-Mode Wireless Receivers with Automatic Frequency Calibration

0.07mm 2, 2mW, 75MHz-IF, fourth-order BPF using source-follower-based resonator in 90nm CMOS

Wideband bandpass filter with ultra-wide stopband based on cross-shaped parallel coupled lines