Abstract:Programmable active bandpass filters (BPFs) have been designed in a chip-scale heterogeneous integration technology, which intimately integrates InP HBTs on a deep scaled CMOS technology. Therefore, the active BPF can leverage both high performance of InP HBT and high density and programmability of CMOS. Two BPF prototypes, consisting of a programmable gain amplifier (PGA), a fifth- or third-order BPF core, and a buffer, have been designed and fabricated. The BPF center frequency can be switched from 0.8 to 2.2 GHz with 150-MHz passband and delivers > 55-dB out-of-band (OOB) rejection for the fifth-order one. Four gain steps: 0, 6, 12, and 16 dB, are enabled by the front PGA to trade off noise and linearity performances. Due to the > 300-GHz f T of InP HBTs, the BPF cores can leverage active-RC architecture for high linearity owing to the close-loop implementation. The fifth-order BPF prototype occupies a 1.5 × 1.02 mm2 area together with pads and draws 106/121 mA from a 3.3-V power supply for 0.8/2.2-GHz bands, respectively, which demonstrates OOB output third-order intercept points (OIP3s) of 22.69/21.25 dBm for 0.8/2.2-GHz bands at the high gain mode. The measurement results suggest the fifth-order BPF core achieves 36.69/35.25-dBm OOB OIP3s. In addition, the designed third-order programmable BPF has been successfully used as a technology yield vehicle to assist the BiCMOS technology development.

A high selectivity, low insertion loss 60GHz-band on-chip 4-pole band pass filter for millimeter wave CMOS SoC

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

A Novel 76 and 94ghz Dual Band Bandpass Filter Using Multilayer Step Impedance Resonators (Sirs)

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

0.8/2.2-GHz Programmable Active Bandpass Filters in InP/Si BiCMOS Technology

A 0.8/2.4 GHz Tunable Active Band Pass Filter in InP/Si BiCMOS Technology

Design of a Miniaturized Dual-Band Double-Folded Substrate Integrated Waveguide Bandpass Filter with Controllable Bandwidths

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Miniaturized left-handed CPW bandpass filter using split ring resonator

High-Selective Bandpass Filters Based on New Dual-Mode Rectangular Strip Patch Resonators

On-Chip CPW Low-Pass Filter with 50–110 GHz Bandstop in 400 Nm Metal Thickness Technology Towards Lab-Level Ka-Band MMICs

Miniaturized millimeter-wave dual-band band-pass on-chip filter in 0.13-μm SiGe BiCMOS

0.07mm 2, 2mW, 75MHz-IF, fourth-order BPF using source-follower-based resonator in 90nm CMOS

A High Linearity Active-Rc Bpf With 70mhz Center Frequency And 22mhz Bandwidth In 65nm Cmos

Hybrid Integration of BAW Resonators with an On-Chip Inductor to Improve the Stopband Rejection of the N78 Band Filter

Cost-Efficient Cmos Rf Tunable Bandpass Filter With Active Inductor-Less Biquads

Design of On-Chip Dual-Band Bandpass Filter Using Lumped Elements in LTCC Technology

A Broadband On-Chip Bandpass Filter Using Shunt Dual-Layer Meander-Line Resonators

On-Chip Millimeter-Wave Integrated Absorptive Bandstop Filter in (Bi)-CMOS Technology