Abstract:In this paper, a new large dither injection technique is proposed for improving linearity in pipelined analog-to-digital converters (ADCs), without losing the dynamic range of the ADCs and deteriorating the corresponding amplifier’s linearity. First, analyses of a proper pipelined ADC’s architecture are performed for large dither injection. Then, a 9-bit capacitive digital-to-analog converter (DAC) with split architecture is developed to inject the dither ranging from −511/1024 least significant bit (LSB) to 511/1024 LSB of the first stage. To counteract the consumption of the correction range by the capacitive injection dither, the novel 6-bit complementary DACs embedded in the comparator threshold generation circuit are proposed to realize comparator dither injection. In addition, the dither injection amplitude is configurable for investigating different amplitude’s effects on the linearity of the ADC. Finally, the proposed dither injection circuit, together with a 16-bit 150 million samples per second (MSPS) ADC, is implemented in a 0.18- $\mu \text{m}$ CMOS technology. The measured results demonstrate the effectiveness of the proposed techniques. The optimum dither is the 9-bit dither, improving not only the spurious free dynamic range (SFDR) of the small signal by at least 13 dB but also that of the large signal by more than 8 dB compared to the case without dither injection. Moreover, dither injection makes the noise floor clean.

Resistive Degeneration Linearization Dynamic Residue Amplifiers for Pipelined ADCs

Modeling of a 14-bit, 100-MS/s pipelined ADC with digital nonlinearity calibration

A Parasitic Elimination Bootstrapped Switch and a Fast Settling Residual Amplifier for High-Speed and High-Resolution Pipelined ADC

A 14bit 500MS/s 85.62dBc SFDR 66.29dB SNDR SHA-less pipelined ADC with a stable and high-linearity input buffer and aperture-error calibration in 40nm CMOS

A Low-Power, High-Speed Open-Loop Residue Amplifier for Pipelined ADCs with Digital Calibration

A High Performance Low Power 12-Bit 40ms/s Pipelined ADC

A 13-Bit 312.5-Ms/s Pipelined SAR ADC with Integrator-type Residue Amplifier and Inter-stage Gain Stabilization Technique

A 100MS/s Linear Gain-Boosted Capacitively Degenerated Dynamic Amplifier for Pipelined ADCs

A 14-bit 300MHz pipelined DEM DAC with enhanced dynamic linearity

Low Power Pipelined A/D Converter in 0.6 Μm Technology

A High Linearity,13bit Pipelined CMOS ADC

A Pipelined Interpolating Analog-to-Digital Converter with Reduced Nonlinearity Error

A Low Power 12-Bit 40ms/s Pipelined ADC with Digital Calibration

A 10-bit 30-MS/s 50mW pipelined A/D converter

9.4 A 182.3dB FoM<inf>s</inf> 50MS/s Pipelined-SAR ADC using Cascode Capacitively Degenerated Dynamic Amplifier and MSB Pre-Conversion Technique

A Fast and Cost-Effective Calibration Strategy of Inter-Stage Residual Amplification Errors for Cyclic-Pipelined ADCs

A Pipelined SAR ADC Reusing the Comparator As Residue Amplifier

Analysis and Design of a Large Dither Injection Circuit for Improving Linearity in Pipelined ADCs

Analysis and optimization of mismatch and parasitics in pipelined ADCs

A 12-Bit 800ms/s Pipelined A/D Converter.

A 13-Bit 312.5-Ms/s Pipelined SAR ADC with Open-Loop Integrator-Based Residue Amplifier and Gain-Stabilized Integration Time Generation