Abstract:This work presents a 14-bit 500 MS/s single-channel pipelined-successive-approximation-register (SAR) analog-to-digital converter (ADC) with an adaptively biased floating inverter amplifier (AB-FIA) as the residue amplifier (RA) and a hybrid reference ripple mitigation (H-RRM) technique to relax the power and area burden on the reference stabilization. Leveraging the adaptively biased architecture in the last stage FIA, the speed and open-loop gain of the proposed two-stage FIA are enhanced compared with the conventional cascode counterpart. Besides, the impact of the reference error on the pipelined-SAR conversion accuracy is alleviated by hybridizing the improved reference ripple cancellation (RRC), reference ripple neutralization (RRN), and reference buffer (RBUF). The improved RRC removes the potential noise coupled from the floating capacitor to counter the decision error during the sub-SAR conversion in the first stage. Meanwhile, the RRN facilitates a rapid reference recovery. These acts constitute the H-RRM, which assists a high-speed and high-resolution pipelined-SAR process with a relaxed integrated reference RBUF with low-power and compact area. The prototype ADC was fabricated in a 28 nm CMOS process; it consumes 6.34 mW total power at 500 MS/s, including 2.4 mW dynamic power of RBUF. It occupies an active area of 0.018 mm $^{2}$ , which the ADC core area of 0.0168 mm $^{2}$ and the area of RBUF with a 2.3 pF decoupling capacitor is 0.00105 mm $^{2}$ . The measured signal to noise and distortion ratio (SNDR) and spurious free dynamic range (SFDR) are 64.2 dB and 80.55 dB with a Nyquist input, respectively, leading to a 170.2 dB Schreier figure-of-merit (FoM) (FoM $_{\mathrm{S}}$ ) and 9.6 fJ/conversion-step Walden FoM (FoM $_{\mathrm{W}}$ ).

A Pipelined SAR ADC Reusing the Comparator As Residue Amplifier

A 12-Bit 2.32gs/s Pipelined/sar Hybrid ADC with a High-Linearity Input Buffer.

A 1.5 Mw 68 Db SNDR 80 Ms/s 2<formula Formulatype="inline"> <tex Notation="TeX">$\times$</tex></formula> Interleaved Pipelined SAR ADC in 28 Nm CMOS

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A 12-Bit 1.5-Gs/s Single-Channel Pipelined SAR ADC with a Pipelined Residue Amplification Stage

A 348-Μw 68.8-Db SNDR 20-Ms/s Pipelined SAR ADC with a Closed-Loop Two-Stage Dynamic Amplifier

A 14bit 320MS/s pipelined-SAR ADC based on multiplexing of dynamic amplifier

A 13-Bit 312.5-Ms/s Pipelined SAR ADC with Integrator-type Residue Amplifier and Inter-stage Gain Stabilization Technique

A 10b 1.25GS/s Residue Post-Amplified Pipelined-SAR ADC with Supply-and-Temperature Stabilized Open-Loop Residue Amplifier.

A 13-Bit 312.5-Ms/s Pipelined SAR ADC with Open-Loop Integrator-Based Residue Amplifier and Gain-Stabilized Integration Time Generation

A 12-bit 100-MSps pipelined-SAR ADC with a time-interleaved second-stage

An energy-efficient reconfigurable 18/12-bit 1MS/s pipelined-SAR ADC

An 871 Nw 96.2 Db SNDR Pipelined Second-Order Noise-Shaping SAR ADC Employing Charge-Efficient CLS-Assisted Residue Amplifier

A 13-Bit 160ms/s Pipelined Subranging-Sar ADC with Low-Offset Dynamic Comparator.

9.1 A 2mW 70.7dB SNDR 200MS/s Pipelined-SAR ADC with Continuous-Time SAR-Assisted Detect-and-Skip and Open-then-Close Correlated Level Shifting.

A 172Db-Fom Pipelined SAR ADC Using a Regenerative Amplifier with Self-Timed Gain Control and Mixed-Signal Background Calibration

A 14b 500 MS/s Single-Channel Pipelined-SAR ADC With Reference Ripple Mitigation Techniques and Adaptively Biased Floating Inverter Amplifier

A Comparator-Reused Dynamic-Amplifier for Noise-Shaping SAR ADC

9.4 A 182.3dB FoM<inf>s</inf> 50MS/s Pipelined-SAR ADC using Cascode Capacitively Degenerated Dynamic Amplifier and MSB Pre-Conversion Technique

A 1.5-MHz BW 81.2-dB SNDR Dual-Residue Pipeline ADC With a Fully Dynamic Noise-Shaping Interpolating-SAR ADC

A Bandwidth-Adaptive Pipelined SAR ADC with Three-Stage Cascoded Floating Inverter Amplifier.