Abstract:AlCrFeNiCu high-entropy alloy (HEA) coating was prepared on Zirconium (Zr) rod by high-speed laser cladding (HSLC) technique. The effect of different laser power and scanning speed on the forming quality of the coating was studied. When the specific energy density was in the range of 3.0–3.2 J/mm 2 , the AlCrFeNiCu HEA coating with good adhesion to the substrate, low dilution rate (small heat affected zone) and no cracks were obtained. The phase structure, microstructure, microhardness, corrosion resistance and high temperature oxidation resistance of the coating were tested and analyzed. The results show that the AlCrFeNiCu HEA coating is composed of 76.9 % BCC phase and 23.1 % FCC phase, in which the BCC phase is mainly composed of disordered BCC phase rich in Cr and Fe elements and ordered B2 phase rich in Al and Ni elements, and the FCC phase is rich in Cu elements. Due to the rapid cooling of HSLC, the coating structure gradually changes from columnar crystal to equiaxial crystal from bottom to top. The hardness of the coating is as high as 805 HV, which may be caused by the solution strengthening effect, lattice distortion effect and slow diffusion effect of HEA. In 3.5 % NaCl solution and 0.1 mol/L KOH solution, the self-corrosion current density of the coating is 4.209 × 10 −8 A/cm 2 and 4.331 × 10 −8 A/cm 2 , respectively. The passivation film on the surface of the coating is composed of a variety of oxides, and the oxygen vacancy density of the passivation film in the two solutions is 2.552 × 10 20 cm −3 and 5.794 × 10 20 cm −3 , with fewer pitting pits on the surface. The structural integrity of the coating can be maintained after 60 min oxidation at 1200 °C. The oxidation process follows the growth kinetics curve, and the surface oxides mainly comprise FeAl 2 O 4 , Al 2 O 3 and Cr 2 O 3 . AlCrFeNiCu HEA coating improves the corrosion resistance and high temperature oxidation resistance of the Zr-4 alloy.

Y-Hf Co-Doped AlCoCrFeNi High-Entropy Alloy Coating with Superior Oxidation and Spallation Resistance at 1100 °C

Y-Hf co-doped AlCoCrFeNi2.1 eutectic high-entropy alloy with excellent oxidation and spallation resistance under thermal cycling conditions at 1100 °C and 1200 °C

Y/Hf-doped AlCoCrFeNi high-entropy alloy with ultra oxidation and spallation resistance

Y-Hf co-doped Al1.1CoCr0.8FeNi high-entropy alloy with excellent oxidation resistance and nanostructure stability at 1200°C

Y-Hf co-doped Al<sub>1.1</sub>CoCr<sub>0.8</sub>FeNi high-entropy alloy with excellent oxidation resistance and nanostructure stability at 1200 C

Y/Hf-doped Al0.7CoCrFeNi high-entropy alloy with ultra oxidation and spallation resistance at 1200 °C

An in-situ oxide-dispersion-strengthened AlCoCrFeNiY high-entropy alloy composite coating prepared by AC-HVAF with superior oxidation and spallation resistance

Microstructure and oxidation behavior of the Y/Ta/Hf co-doped AlCoCrFeNi high-entropy alloys in air at 1100 °C

Effect of Al content on the oxidation behavior of Y/Hf-doped AlCoCrFeNi high-entropy alloy

A Novel NiCoCrAlPt High-Entropy Alloy with Superb Oxidation Resistance at 1200 °C

Unraveling the oxidation mechanism of Y-doped AlCoCrFeNi high-entropy alloy at 1100 °C

Mechanical properties of nanostructured CoCrFeNiMn high-entropy alloy (HEA) coating

AlCoCrNiMo high-entropy alloy as diffusion barrier between NiAlHf coating and Ni-based single crystal superalloy

Superior Oxidation Resistance of a Y-Hf Co-Doped Al18Co30Cr10Fe10Ni32 Eutectic High-Entropy Alloy at 1100-1300 °C

Air plasma sprayed high-entropy AlCoCrFeNiY coating with excellent oxidation and spallation resistance under cyclic oxidation at 1050–1150 °C

Thermal Stability and Hot Corrosion Performance of the AlCoCrFeNi2.1 High-Entropy Alloy Coating by Laser Cladding

Y-doped AlCoCrFeNi2.1 eutectic high-entropy alloy with excellent oxidation resistance and structure stability at 1000°C and 1100°C

A Comparative Study on the Oxidation Behavior and Failure Mechanisms of Conventional NiCoCrAl Alloy and In-Situ Composite AlCoCrFeNi2.1 Eutectic High-Entropy Alloy at 1300 °C

Microstructure, corrosion resistance and high temperature oxidation properties of AlCrFeNiCu high-entropy alloy coating by high-speed laser cladding

Microstructure evolution and properties of Fe-Ni-Cr-Co-Mo-W high-entropy alloy coatings by plasma surface alloying technology

Wear resistance of FeCoCrNiMnAlx high-entropy alloy coatings at high temperature