Abstract:For a detailed understanding of fuel retention characterization, especially in-depth profile analysis of plasma facing materials, radio frequency glow discharge optical emission spectroscopy (RF-GDOES) method was applied to determine the deuterium depth concentration. Tungsten or titanium targets were co-deposited in deuterium atmosphere by magnetron sputtering, and these deposited films with different deuterium contents and film thicknesses were used as the standard samples for RF-GDOES measurement. Rutherford backscattering spectroscopy (RBS) and thermal desorption mass spectrometry (TDS) were used to measure the metal and deuterium concentrations in the standard films, respectively. After the standardization of deuterium concentration and sample sputtering rate when tested by RF-GDOES, deuterium concentration and depth profiling of deuterium exposed tungsten samples were obtained and subsequently verified by compared with results by TDS. Results showed the deuterium concentration in deuterium-exposed tungsten has a high concentration peak about 0.002-0.013 at.fr. within 125 nm near-surface, and then reduced by two orders of magnitude from surface to depth with a minimum concentration of few 10(-5)at.fr. With increasing the incident deuterium fluence, deuterium concentration increased obviously in the first 6 mu m near the surface. Under low incident fluence, the total released deuterium amounts obtained from RF-GDOES and TDS methods agree within the experimental error. However, the total released deuterium amounts measured by RF-GDOES were smaller than those of the TDS method under high fluence due to reason of the increasing diffusion depth and inhomogeneity of deuterium in tungsten.

Comparing deuterium retention in heavy ion damaged tungsten measured by glow discharge optical emission spectroscopy, nuclear reaction analysis and thermal desorption spectroscopy

Deuterium retention in helium-irradiated tungsten

Dependence of deuterium retention on helium ions irradiation in tungsten

Deuterium Retention in Heavy-Ion and Helium-Ion Sequentially Irradiated Tungsten

Dependence of blistering and deuterium retention on damage depth in damaged tungsten exposed to deuterium plasma

Deuterium retention and thermal conductivity in ion-beam displacement-damaged tungsten

Experimental Measurement of Deuterium Concentration and Depth Profiling in Tungsten by Radio Frequency Glow Discharge Optical Emission Spectroscopy

Surface Modification and Deuterium Retention of High Energy Rate Forging W-Y2O3exposed to Deuterium Plasma

Deuterium Distribution and Behavior of Blisters in Pre-Damaged and Undamaged Tungsten

Irradiation hardening and deuterium retention behaviour of tungsten under synergistic irradiations of 3.5 MeV Fe 13+ ions and deuterium plasma

First study of the location of deuterium in displacement-damaged tungsten by nuclear reaction analysis in channeling configuration

Blistering Behavior and Deuterium Retention in Tungsten Vanadium Alloys Exposed to Deuterium Plasma in the Linear Plasma Device STEP

Effects of Tantalum Alloying on Surface Morphology and Deuterium Retention in Tungsten Exposed to Deuterium Plasma

Temperature dependence of deuterium retention at displacement damage in tungsten

Characterization on deuterium retention in tungsten target using spatially resolved laser induced desorption-quadrupole mass spectroscopy

Surface modification and deuterium retention in hot-rolled potassium doped tungsten alloy exposed to deuterium plasma

Deuterium retention and transport in ion-irradiated tungsten exposed to deuterium atoms: role of grain boundaries

Deuterium retention in tungsten and tungsten alloys exposed to pure and impurities seeding deuterium plasma

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Effect of 3 MeV Fe<SUP>11+</SUP> ions pre-damage on blistering and deuterium retention in two tungsten grades

Reduced D Trapping by Plasma-Implanted He Nanobubbles in Radiation Damaged Tungsten