Abstract:The built up of the slag layer is a character of the entrained-flow gasifier, and its thickness distribution and heat transfer characteristics affect the stable operation of gasification, which is closely related to the thermal conductivity of molten slag. A non-stationary hot wire experimental method and a reverse nonequilibrium molecular dynamics simulation method were combined to investigate the thermal conductivity of the SiO2-Al2O3-CaO-Fe2O3-MgO molten slag with a mass ratio of CaO ranging from 5 to 25 wt.%. The slag microstructure information of the distribution of oxygen and tetrahedron (2ll was calculated by molecular dynamics simulation. A good agreement within the deviation of 18% between the measured and calculated thermal conductivity over the entire operating temperature range is observed, and one can find that thermal conductivity decreases significantly as the CaO content increased. The principal pathway for CaO modifying the network structure is the connection between two tetrahedral structures by generation of the Si-O-Ca and Al-O-Ca through the fracture of Si-O-Si and Si-O-Al. The rise of CaO promotes the formation of non-bridging oxygen (NBO) and the decomposition of bridging oxygen. The existence of NBOs leads to an enhancement of anharmonicity and shortens the interatomic distance in the tetrahedral structure, which aggravates phonon scattering to reduce phonon mean free path, thereby decreasing the thermal conductivity. Since the phonon propagation is restricted to short-range tetrahedron separated by structural disorder, the Q(4) structure is the most sensitive to the addition of CaO. An equivalent molar concentration of the Q(4) tetrahedron (XQ(4)) is defined and the approximate positive linear relationships between the thermal conductivities and XQ(4) are obtained. (C) 2020 Elsevier Ltd. All rights reserved.

Investigation in CaO-SiO<sub>2</sub>-CaF<sub>2</sub>-C slags during the sintering and melting process

Dissolution of Carbon-Containing Species in CaO-SiO 2 -Al 2 O 3 Slag

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

The Study on the Interface Reaction Characteristics of Different Binary Slag, CaO – MgO, Al2O3 – CaO, Al2O3 – MgO, SiO2 – CaO, SiO2 - MgO

Qualitative, Quantitative and Mechanism Research of Volatiles in the Most Commonly Used CaO–SiO2–CaF2–Na2Ο Slag During Casting Process

Dissolution of CaO in SiO2-CaO-Al2O3 Slag in Si Production

Melting Performance for Selected CaO-5%MgO-Al_2O_3-SiO_2-0.5%‘FeO' Slag With Low Silica

Investigation on Crystallization of CaO‐Al2O3‐B2O3‐BaO Slag Using Differential Scanning Calorimeter and In Situ High‐Temperature Raman Spectroscopy

Effect of CaF2 and CaO/Al2O3 ratio on evaporation and melting characteristics of low-fluoride CaF2–CaO–Al2O3–MgO–TiO2 slag for electroslag remelting

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Investigation of the Effect of P2O5 and CaF2 on the Crystallization Behavior of La2O3-bearing Calcium–silicate–aluminum Slags Using the Single Hot Thermocouple Technique

Effects of TiO2 and CaO/Al2O3 on Melting Characteristics, Surface Tension, and Structure Electroslag‐Remelting‐Type Low‐Fluorine Slag

Numerical Investigation of Basic Oxygen Furnace Slag Modification with Gas Bottom-Blowing and SiO2 Modifier

The Effect of SiC on the Phase Composition and Structure of Mixed Slag

Effect of CeO2 Content on Melting Performance and Microstructure of CaO-Al2O3-SiO2-MgO Refining Slag

Dissolution Kinetics of SiO2 into CaO-Fe2O3-SiO2 Slag

Investigation of fluoride evaporation from CaF2–CaO–Al2O3–MgO–TiO2–(Li2O) slag for electroslag remelting

Structural Characteristics of CaO-SiO2-Al2O3-FeO Slag with Various FeO Contents Based on Molecular Dynamics Simulations

Corrosion behavior of CaO–Al2O3–SiO2–MgO-Cr2O3 slag on MgO refractory brick for smelting of chromite

Thermal Conduction Mechanism Based on Microstructural Transformations of Molten Slag: the Role of Calcium Oxide

Dissolution behavior of spent MgO–C refractory in the CaO–SiO2–FeO slag system as a steelmaking flux