Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Investigation of fluoride evaporation from CaF2–CaO–Al2O3–MgO–TiO2–(Li2O) slag for electroslag remelting

Effect of CaF2 and CaO/Al2O3 ratio on evaporation and melting characteristics of low-fluoride CaF2–CaO–Al2O3–MgO–TiO2 slag for electroslag remelting

Fluoride vaporization and crystallization of CaF2–CaO–Al2O3–(La2O3) slag for vacuum electroslag remelting

Effect of Ce2O3 on the fluoride vaporization of CaF2–CaO–Al2O3-(Ce2O3) slag used for vacuum electroslag remelting

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Phase Separation of Alkaline Earth Fluorosilicate Glass: A Strategy to Suppress Fluoride Evaporation

Effects of TiO2 and CaO/Al2O3 on Melting Characteristics, Surface Tension, and Structure Electroslag‐Remelting‐Type Low‐Fluorine Slag

A combined computational-experimental study on the effect of Na2O on the fluoride volatilization in molten slags

Qualitative, Quantitative and Mechanism Research of Volatiles in the Most Commonly Used CaO–SiO2–CaF2–Na2Ο Slag During Casting Process

Study on the Melting Characteristics of Slag from the Incinerator of Hazardous Wastes Containing Fluorine and Chlorine

Effects of Fluorides on NaF Vaporization during Mold Powder Melting by Thermodynamic Equilibrium Calculation

Melting Point and Viscosity Measurement of Continuous Casting Mold Flux with Volatiles

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Study on the Melting Temperature of CaF2-CaO-MgO-Al2O3-TiO2 Slag under the Condition of a Fixed Ratio of Titanium and Aluminum in the Steel during the Electroslag Remelting Process

Dissolution behavior of spent MgO–C refractory in the CaO–SiO2–FeO slag system as a steelmaking flux

Evolution of Interface Characteristic between Quicklime and CaO–SiO2–FetO–MgO Melt during Slag‐Forming Procedure in Converter under Different Times

Analysis of the melting process of carbon-bearing pellets in iron bath, slag bath and graphite crucible

Effect of FeO Content on Foaming and Viscosity Properties in FeO-CaO-SiO2-MgO-Al2O3 Slag System

Effect of B2O3 on the Melting Temperature and Viscosity of CaO–SiO2–MgO–Al2O3–TiO2–Cr2O3 Slag

Effect of Fluorine on the Crystallization of Li2O-Al2O3-SiO2 Glasses

Study of Thermodynamic for Low-Reactive CaO-BaO-Al2O3-SiO2-CaF2-Li2O Mold Flux Based on the Model of Ion and Molecular Coexistence Theory