Abstract:The piloted premixed jet burner (PPJB) methane–air flame series have been developed to study turbulence–chemistry interactions in lean and highly turbulent premixed flames. The two flames with the largest jet velocities, denoted as PM1-150 and PM1-200, remain challenging for combustion models up to the present. In this work, the flames with the lowest and highest jet velocities, PM1-50 and PM1-200 respectively, are simulated using a hybrid RANS-PDF method to examine the composition evolution and the mixing model performance through Lagrangian particle tracking, and to reveal the controlling physio-chemical processes through particle-level sensitivity analysis. The mixing-reaction budget analysis reveals that for the PM1-50 flame, the implied combustion modes by IEM and EMST mixing models are different: the simulation with EMST is consistent with a flame propagation process, whereas the one with IEM is consistent with an autoignition process. In this regard, for the PM1-50 in the flamelet regime, EMST predicts the correct combustion process whereas IEM does not, despite the fact that the radial profiles of species concentration predicted by these two models are almost identical and are both in good agreement with the experimentally measured values. For the PM1-200 flame closest to global blow-off, EMST and IEM yield similar characteristics: both predict a balance between mixing and reaction in the reaction zone, and both are consistent with flame propagation processes. Due to strong turbulent mixing, the mixing in the preheat zone is greatly enhanced. The change of combustion modes predicted by IEM, i.e. from an autoignition process in PM1-50 to a flame propagation process in PM1-200, is further explored by examining some representative particle trajectories in progress variable space. The PDFs and the mixing-reaction budgets of the progress variable predicted by IEM and EMST demonstrate that the localness of mixing in composition space is essential for a flame in the flamelet regime (PM1-50), while it is less important for a flame in the broken reaction zone regime (PM1-200). The particle-level sensitivity approach has been augmented to further investigate the sensitivities of combustion process to mixing and reaction with an attenuation factor R for the overall reaction rate being introduced to quantify the sensitivities to chemical reaction. It is observed that the sensitivities in PM1-50 and PM1-200 are very different. For PM1-50, the sensitivities of the progress variable to the mixing model constant Cϕ and to the attenuation factor R are both positive, indicating that the reaction progress can be promoted by enhancing either mixing or reaction. In contrast, for PM1-200, the progress variable at the upstream location shows negative sensitivities to Cϕ, which indicates that enhancing mixing suppresses combustion progress due to the fact that the flame is already near the blow-off limit. At downstream locations, the sensitivities of progress variable to reaction is significantly larger than its sensitivity to mixing, indicating that the controlling process during the reignition stage is chemical reaction. These sensitivities are insightful in explaining the observed trends in previous parametric studies of Cϕ for high speed PPJB flames, in which it is found that increasing Cϕ alleviates the overpredition of reaction progress at the upstream location but does not help improve the prediction at the downstream location where the controlling process is chemical reaction.

Analysis of the Mixing and Emission Characteristics in a Model Combustor

Analysis and Experiments about the Characteristics of Mixing Process in the Premixed Gas Turbine

Efficient Emission Modelling in Lean Premixed Flames with Pre-Tabulated Formation Characteristics

Kinetics Modeling on NOx Emissions of a Syngas Turbine Combustor Using Rich-Burn, Quick-Mix, Lean-Burn Combustion Method

An analytic model for the effects of nitrogen dilution and premixing characteristics on NOx formation in turbulent premixed hydrogen flames

Kinetics Modeling On Nox Emissions Of A Syngas Turbine Combustor Using Rql Combustion Method

Effects of Reactant Injection Conditions on Diffusion Combustion of Natural Gas in a Laboratory-scale Combustor

Experimental and Numerical Investigation of the Non-Reacting Flow in a High-Fidelity Heavy-Duty Gas Turbine DLN Combustor

Effects of Air and Oxy-Fuel Atmospheres on Flamelet Modeling of Pollutant Formation in Laminar Counterflow Solid Fuel Flames

Modeling of Supercritical-Pressure Turbulent Combustion of Hydrocarbon Fuels Using A Modified Flamelet-Progress-Variable Approach

Carrier-phase Direct Numerical Simulation and Flamelet Modeling of NOx Formation in a Pulverized Coal/ammonia Co-Firing Flame

Investigation of Mixing Model Performance in Transported Pdf Calculations of Turbulent Lean Premixed Jet Flames Through Lagrangian Statistics and Sensitivity Analysis

Analysis of Air-Staged Combustion of NH3/CH4 Mixture with Low NOx Emission at Gas Turbine Conditions in Model Combustors

Study on premixing uniformity and emission of R0110 combustor

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Kinetics Modeling of NOx Emissions Characteristics of a NH3/H2 Fueled Gas Turbine Combustor

Numerical Investigation on NH 3 /H 2 /Air Combustion Flow in a Multiple Direct-Injection Combustor

Combustion characteristics of ignition processes for lean premixed swirling combustor under visual conditions

A Numerical Study of the Fuel/air Mixing Law Specific to the Premixing Section of a Gas Turbine Combustor

Partially Premixed Combustion Simulation Using a Novel Transported Multi-Regime Flamelet Model

Experimental Investigation of Lean Methane–Air Laminar Premixed Flames at Engine-Relevant Temperatures