Abstract:With the development of the designing and manufacturing level for micro-electromechanical system (MEMS) gyroscopes, the control circuit system has become a key point to determine their internal performance. Nevertheless, the phase delay of electronic components may result in some serious hazards. This study described a real-time circuit phase delay correction system for MEMS vibratory gyroscopes. A detailed theoretical analysis was provided to clarify the influence of circuit phase delay on the in-phase and quadrature (IQ) coupling characteristics and the zero-rate output (ZRO) utilizing a force-to-rebalance (FTR) closed-loop detection and quadrature correction system. By deducing the relationship between the amplitude-frequency, the phase-frequency of the MEMS gyroscope, and the phase relationship of the whole control loop, a real-time correction system was proposed to automatically adjust the phase reference value of the phase-locked loop (PLL) and thus compensate for the real-time circuit phase delay. The experimental results showed that the correction system can accurately measure and compensate the circuit phase delay in real time. Furthermore, the unwanted IQ coupling can be eliminated and the ZRO was decreased by 755% to 0.095°/s. This correction system realized a small angle random walk of 0.978°/√h and a low bias instability of 9.458°/h together with a scale factor nonlinearity of 255 ppm at room temperature. The thermal drift of the ZRO was reduced to 0.0034°/s/°C at a temperature range from -20 to 70 °C.

Development of an Effective Method to Reduce Mechanical Coupling Error in a Micro Quartz Tuning Fork Gyroscope

A MICROMECHANICAL MODE-MATCHED GYROSCOPE USING STIFFNESS NONLINEARITY AND ELECTROSTATIC TUNING

One-time Frequency Sweep to Eliminate IQ Coupling in MEMS Vibratory Gyroscopes

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

Development of V-Shaped Beam on the Shock Resistance and Driving Frequency of Micro Quartz Tuning Forks Resonant Gyroscope

An automatic Q-factor matching method for eliminating 77% of the ZRO of a MEMS vibratory gyroscope in rate mode

A System-Level Simulation Approach for Analyzing MEMS Gyroscope Manufacture Error

A Novel Mechanical Frequency Tuning Method Based on Mass-Stiffness Decoupling for MEMS Gyroscopes

Vibration Sensitivity Reduction of Micromachined Tuning Fork Gyroscopes through Stiffness Match Method with Negative Electrostatic Spring Effect

MEMS Torsional Pendulum Gyroscope With Fishbone-Like Sense Electrodes for Minimizing Quadrature Electrical Readout

Analysis of the Mechanical Coupling Characteristics of a Monolithic Tri-Axis MEMS Gyroscope

Study on the Effect of Quadrature Error on In-Phase Output Based on Electrostatic Compensation

A Real-Time Circuit Phase Delay Correction System for MEMS Vibratory Gyroscopes

Separation and identification for structure error parameter in vibratory silicon MEMS gyroscopes

Mechanism Analysis and System Identification of the Quadrature Error in MEMS Gyroscope

Design and optimization of a resonant output frequency gyroscope for robust sensitivity and bandwidth performance

Optimal Design Of A Center Support Quadruple Mass Gyroscope (Csqmg)

Research on the Zero-Rate Output Compensation for MEMS Vibratory Gyroscopes

Design of A Tuning-Fork Gyro Made of Quartz

Design and implementation of a fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope for robustness improvement

A Low-Complexity In-Run Modal Frequency Tuning Method for MEMS Disk Gyroscopes Without Gain Calibration and Phase Shifting