Abstract:Presently Si-based field-effect transistors (FET) are approaching their physical limit and challenging Moore's law for their short-channel effect, and further scaling their gate length down to the sub-10 nm region is becoming extremely difficult. Two-dimensional (2D) layered semiconductors with atom-scale uniform thicknesses and absence of dangling bonds on the interface are considered as potential channel materials to support further miniaturization and integrated electronics. Wu F, et al. (2022 Nature 603 259) have successfully fabricated a FET with gate lengths below 1 nm using atomically thin molybdenum disulfide with exceptional device performance. This breakthrough has greatly encouraged further theoretical predictions regarding the performance of 2D devices. Additionally, 2D SnS exhibits high carrier mobility, anisotropic electronic properties, and stabilized in ambient condition conducive to advanced applications in 2D semiconductor technology. Herein, we explore the quantum transport properties of sub-5 nm monolayer (ML) SnS FET using first-principles quantum transport simulation. Considering the anisotropic electronic SnS, the double-gated-two-probe device model is constructed along the armchair and zigzag directions of ML SnS. After test five kinds of doping concentrations, a doping concentration of 5×10 13 cm -2 is the best one for SnS FET. We also used the underlap (UL) with range of 0, 2, and 4 nm to improve the device performance. On-state current ( I on ) is an important parameter for evaluating the transition speed of a logic device. A higher I on of a device can help to increase the switching speed of high-performance (HP) servers. The main conclusions are as follows. 1) I on of the n-type 2 nm (UL=4 armchair), 3 nm (UL=2), 4 nm (UL=3), 5 nm (UL=0) and the p-type 1 nm (UL=2 zigzag), 2 nm (UL=2 zigzag), 3 nm (UL=2,4 zigzag), 4 nm (UL=2,4 zigzag), and 5 nm (UL=0, armchair/zigzag) gate-length devices can meet the standards for HP applications for the next decade in the International Technology Roadmap for semiconductors (ITRS, 2013 version). 2) I on of the n-type device along the armchair direction (31-2369μA/μm) are larger than that in the zigzag direction (4.04-1943μA/μm), while p-type along the zigzag direction (545-4119μA/μm) are larger than that in the armchair direction (0.7-924μA/μm). Therefore, the p-type ML GeSe MOSFETs have a predominantly anisotropic current. 3) I on of the p-type 3 nm gate-length (UL=0) device along the zigzag direction has the highest valued 4119 μA/μm is 2.93 times larger than that in the same gate-length UL=2 (1407μA/μm). Hence, an overlong UL will weaken the performance of the device because the gate of the device cannot well control the UL region. Thus, a suitable length of UL for FET is very important. 4) Remarkably, I on of the p-type devices (zigzag), even at a 1 nm gate-length, can fulfill the requirements of HP applications for the next decade in the ITRS, with a value as high as 1934 μA/μm. To our knowledge, this is the best-performing device material reported at 1 nm gate length. 5) Subthreshold swing (SS) evaluates the control ability of the gate in the subthreshold region. The better the gate control, the smaller SS the device has. The limit of SS for traditional FETs is 60 mV/dec (at room temperature). Values of SS for ML SnS FET alone zigzag direction are less than those along the armchair direction because the leakage current is influenced by the effective mass.

Layer‐Controlled Low‐Power Tunneling Transistors Based on SnS Homojunction

Characteristics of InAs/GaSb Line-Tunneling FETs with Buried Drain Technique

High-performance Sub-5nm Monolayer Tin Sulfide (SnS) Field-effect Transistors: a First principles Study

A Symmetric Tunnel Field-Effect Transistor Based on MoS2/Black Phosphorus/MoS2 Nanolayered Heterostructures

A Novel High-Performance Planar InAs/GaSb Face-Tunneling FET With Implanted Drain for Leakage Current Reduction

Vertical SnS 2 /si Heterostructure for Tunnel Diodes

MoS2/Si Tunnel Diodes Based on Comprehensive Transfer Technique

Experimental Investigation of a Novel Junction-Modulated Hetero-Layer Tunnel FET with the Striped Gate for Low Power Applications.

Sub-10 Nm Tunneling Field-Effect Transistors Based on Monolayer Group IV Mono-Chalcogenides

A Novel Planar InAs/Si Hetero-TFET with Buried Drain Design and Face-tunneling Technique

Tunneling Junction as Cold Source: Toward Steep-Slope Field-Effect Transistors Based on Monolayer MoS 2

A Novel Tunnel FET Design Through Adaptive Bandgap Engineering with Constant Sub-Threshold Slope over 5 Decades of Current and High $\text{i}_{\mathrm {on}}/\text{i}_{\mathrm {OFF}}$ Ratio

Si/SnS2 Vertical Heterojunction Tunneling Transistor with Ionic-Liquid Gate for Ultra-Low Power Application

Enhanced Performance of Gesn Source-Pocket Tunnel Field-Effect Transistors for Low-Power Applications

2D Steep‐Slope Tunnel Field‐Effect Transistors Tuned by van der Waals Ferroelectrics

Sub-5 Nm Monolayer MoS2 Transistors Toward Low-Power Devices

Tunable Snse2/Wse2 Heterostructure Tunneling Field Effect Transistor

High performance tunnel field-effect transistor by gate and source engineering.

Thickness-controlled black phosphorus tunnel field-effect transistor for low-power switches

On-State Current Optimization for SnSe2 Tunneling Field Effect Transistors with Silicene Electrodes

Towards ultralow-power and high-speed electronics: Tunnel transistor based on single-chain Tellurium