Abstract:Titanium alloys are widely used in aviation, marine, automotive, offshore, and medical fields. However, their poor wear resistance reduces the safety and reliability of components during service. Few study has been previously conducted on the wear resistance enhancement of titanium alloys (including Ti–6Al–4V alloy) processed by mechanical cutting. High-speed ultrasonic vibration cutting (HUVC) is an effective approach for improving the machinability of titanium alloys. In this study, we attempted to utilize HUVC improving the wear resistance of titanium alloys. After conducting high-speed turning (cutting speed within the range of 200–300 m/min), the surface integrities (surface roughness, microstructure, in-depth micro-hardness, and residual stress) of conventional cutting (CC)- and HUVC-machined samples were characterized. Experimental results demonstrated that, compared with CC, HUVC achieved a thicker plastic deformation layer (greater than 46.93 μm), lower surface roughness, higher surface micro-hardness (greater than 433 HV 0.05 ), and higher compressive residual stress (up to −840 MPa). Moreover, surface nanocrystallization and gradient nanostructured layer were observed in HUVC-machined Ti–6Al–4V samples. In addition, compared with CC, HUVC effectively further reduced the friction coefficient and worn volume loss (decreased by 20.98%–25.59%) and ultimately improved the wear resistance. The hardness has a higher influence on the wear resistance of the machined Ti–6Al–4V alloy than the other surface integrity factors. Therefore, the proposed mechanical cutting operation was confirmed to improve the wear resistance of titanium alloys.

High-temperature Wear Behavior of Micro- and Ultrananocrystalline Diamond Films Against Titanium Alloy

Enhancing High-Temperature Wear Resistance by Constructing the Amorphous-Crystal Heterointerface Structure in WO3/TiO2 Composite Coatings

Influences of different temperatures on the mechanical properties and wear resistance against Ti6Al4V of Ti doped diamond-like carbon deposited on cemented carbide

Wear mechanism of diamond-cutting tool in nano-cutting polycrystalline γ-TiAl alloy based on molecular dynamics simulation

Research on high temperature wear resistance mechanism of CrN/CrAlN multilayer coatings

Ultrananocrystalline Diamond Film: Tribological Studies Against Metal and Ceramic Balls

Preparation of Ti-coated diamond/WC-Co-based cemented carbide composites by microwave-evaporation titanium-plating of diamond particles and microwave hot-press sintering

Response of tribological behaviors to microstructural characteristics of Ti-40Al-10V alloy at high temperatures

The Microstructure and Wear Properties of Diamond Composite Coatings on TC4 Made by Induction Brazing

Mass production and cutting performance of diamond coated cutting tools for machining titanium alloys

High Temperature Oxidation and Wear Behaviors of Ti-V-Cr Fireproof Titanium Alloy

Understanding wear mechanisms of TiSiCN/Zr(C)N coatings at elevated temperatures

High-temperature oxidation and wear properties of TiC-reinforced CrMnFeCoNi high entropy alloy composite coatings produced by laser cladding

Influence of annealing temperature on microstructure evolution of TiAlSiN coating and its tribological behavior against Ti6Al4V alloys

Wear Behavior of TiN/TiAlSiN Nanocomposite Multilayer Coatings from Ambient Temperature to Medium Temperature

Microwave plasma CVD of diamond films on high concentration alloys: Microstructure, hardness and wear properties

Temperature-induced wear transition in ceramic-metal composites

High-Temperature Tribology of Selective Laser-Melted Titanium Alloys: Role of Adhesive Wear

High temperature wear behavior of nanodiamond reinforced nickel-aluminum composite coatings

Effect of Temperature on Wear Behavior in a Ti-V-Cr Base Fireproof Titanium Alloy

Effect of high-speed ultrasonic vibration cutting on the microstructure, surface integrity, and wear behavior of titanium alloy