Abstract:Shorter technology enable us to create higher speed oscillators which can provide better resolution in time domain. Therefore, a simple ADC using voltage (or current) controlled oscillator (VCO) and a counter can be implemented using this approach. Conceptually, the operation order in this ADC is similar to a conventional ΣΔ modulator. The CCO integrates frequency to produce output in the form of phase. And the number of stages in the CCO determines the quantization levels (or phase resolution). The difference of quantized phase output produces a frequency proportional to the input signal. Therefore, unlike, a conventional ΣΔ modulator no feedback is required for a first order noise shaping. In order to achieve a low power for moderate performance two key techniques have been used: a) a cross-coupled voltage to current (V/I) converter to achieve non-linearity cancellation (mainly 3rd-order harmonic), and b) a stack structure to share current between V/I converter and CCO to reduce power. This ADC has been simulated using models of typical 130nm CMOS technology. In SPICE simulation, SQDR/SFDR of 67.5 dB/71 dB is achieved over a total signal bandwidth of 5 MHz for an input swing of 300mV (Vpp) for typical corner at room temperature. The analog blocks consumed a total of 96.5μW from a regulated 1.2V supply, whereas, the digital blocks consumed an estimated power of 1.1 mW. Since, the major circuit blocks are digital in nature, the presented circuit is highly amenable with technology scaling.

A Purely-Vco-Based Single-Loop High-Order Continuous-Time Sigma Delta Adc

A Purely-Vco-based Single-Loop High-Order Continuous-Time ΣΔ ADC.

Vco-Based Continuous-Time Sigma Delta Adc Based on A Dual-Vco-Quantizer-Loop Structure

A Second-Order Purely VCO-Based CT $\delta\sigma$ ADC Using a Modified DPLL Structure in 40-Nm CMOS

A VCO Based Continuous Time Delta Sigma ADC with 10mhz BW 55db SNR and 42db SNDR

A 1.8mW 2MHz-BW 66.5dB-SNDR ΔΣ ADC using VCO-based integrators with intrinsic CLA

An OTA-Less Second-Order VCO-Based CT $\delta\sigma$ Modulator Using an Inherent Passive Integrator and Capacitive Feedback

A Second-Order VCO-Based ΔΣ ADC with Fully Digital Feedback Summation.

A Closed-Loop VCO-based 1-1 SMASH CT ΔΣ ADC Architecture

A Scaling-Friendly Low-Power Small-Area <formula Formulatype="inline"><tex Notation="TeX">$\Delta\Sigma$</tex></formula> ADC with VCO-Based Integrator and Intrinsic Mismatch Shaping Capability

A 10MHz-BW, 5.6mW, 70dB SNDR ΔΣ ADC using VCO-based integrators with intrinsic DEM

A Synthesizable 0.0060mm2 VCO-Based Delta Sigma Modulator with Digital Tri-level Feedback Scheme.

A Synthesis Friendly VCO-Based Delta-Sigma ADC with Process Variation Tolerance

A 1.2 mW 67.5 dB SQDR VCO-based ΣΔ ADC with Non-linearity Cancellation Technique

A Survey of Voltage-Controlled-oscillator-based ΔΣ ADCs

Highly Linear Continuous-Time Mash Delta Sigma Adc With Dual Vco-Based Quantizers

A 74.5-dB Dynamic Range 10-MHz BW CT-ΔΣ ADC With Distributed-Input VCO and Embedded Capacitive- π Network in 40-nm CMOS

A Fully Dynamic 4-Channel 13b Simultaneous Sampling Incremental ΔΣ ADC Using Cascoded Floating-Inverter-Amplifier and Code Division Multiplexing Technique

Analysis of VCO-Based Continuous-Time ΣΔ ADCs Using a Subset of Phases as the Feedback Signal

Second-order VCO-based ΔΣ ADC Using a Modified DPLL

Advances in Voltage-Controlled-Oscillator-Based ΔΣ ADCs.