Abstract:The as-laid embedment is a key design element of deep-water pipelines, as it significantly affects the longitudinal and transverse pipe-soil interaction and thermal insulation. Due to the small-amplitude oscillations driven by the sea state as well as lay vessel motions, the as-laid embedment is significantly greater than the predictions derived from static penetration analyses. This paper presents a numerical study into the cyclic embedment behavior of deep-water pipelines in soft clay using a recently developed sequential limit analysis (SLA) technique. It directly models the evolution of model geometry and material properties through a consecutive series of small displacement analyses and incorporates the effect of strain softening and strain rate on soil strength. A rigid plane-strain pipe section is pushed-in-place and then subjected to small-amplitude cyclic lateral displacements, with an accumulated lateral pipe displacement of up to 60 diameters. Careful comparisons between the numerical results with published centrifuge data are provided to demonstrate the robustness of SLA, in terms of pipe invert trajectory and soil resistance, followed by an extensive parametric study investigating the effect of strain rate, strain softening, oscillation amplitude, and loading history. More detailed aspects of the cyclic loading behavior are discussed with reference to soil failure mechanisms and bearing capacity yield envelopes. A strong correlation between accumulated lateral pipe displacement and pipe embedment is identified, regardless of the varying oscillation amplitudes, and soil buoyancy is found to play the most significant role in determining the final pipe embedment. The present study aims to assist the development of a macro-element plasticity pipe-soil model that can be incorporated into simplified three-dimensional (3D) pipeline-seabed models, as well as to promote the application of SLA to model complex large-displacement pipe-soil interaction problems.

Modeling Soil Loss By Water Infiltration Through Sewer Pipe Defects

Physical and Analytical Modeling of Soil Loss Caused by a Defective Sewer Pipe with Different Defect Locations

A Coupled Discrete Element Model for the Simulation of Soil and Water Flow Through an Orifice

Physical modeling on sand erosion around defective sewer pipes under the influence of groundwater

Experimental Study on Submerged Sand Erosion through a Slot on a Defective Pipe

Improved Model for Contaminant Intrusion Induced by Negative Pressure Events in Water Distribution Systems

An analytical solution for steady seepage into a defective pipe

Two-dimensional Pipe Leakage Through a Line Crack in Water Distribution Systems

An Approximate Model on Three-Dimensional Groundwater Infiltration in Sewer Systems.

Three-dimensional pipe leakage assessment in water distribution system

Experimental Study on the Soil Erosion through a Defective Pipe under the Cyclic Infiltration-Exfiltration Flow

Numerical Studies on Filter of Piping in Broadly Graded Cohesionless Soils

An Approximate Solution for Two-Dimensional Groundwater Infiltration in Sewer Systems

Numerical Modelling of Pipe-Soil Interaction for Marine Pipelines in Sandy Seabed Subjected to Wave Loadings

Failure Prediction Model and Influence Parameter Analysis of Buried Cast Iron Water Mains

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Failure evolution and mechanism of ground collapse due to exfiltration of shallowly buried water pipeline

Modeling Pipe–Soil Interaction under Lateral Movement Using Material Point Method

Dynamic Analyses of Pipes in Saturated Soil under Traffic Loads