Abstract:Defects in sewer pipes are the leading cause of soil erosion and road collapse, but the effect of the defect location is unclear. Laboratory model tests were conducted to investigate the erosion and loss of sandy soil adjacent to a defective sewer pipe. Five defect locations around a round pipe were examined with a physical model in the laboratory. Particle image velocimetry (PIV) shows that the erosion in the soil around the pipe is limited to a narrow region above the defect in the pipe, and the defect location affects the soil erosion and flow rates. The eroded soil region did not change when the defect was located in the top half of the pipe, whereas the eroded region expanded when the defect is located in the bottom half of the pipe. The eroded region was more than two times wider for a pipe with a defect at the invert than a defect at the crown. Flow rate analysis demonstrated that the soil and water flow rates are reduced when the location of the defect is changed from the crown to the invert, and the time it takes during erosion is increased. The ratio between the soil and water flow rates is constant until the erosion cavity reaches the defect. The soil/water flow rate ratio is not affected by the water level or the defect location and it only depends on the ratio between the defect size and the particle size. The ratio between the soil/water flow rates and the defect/particle sizes can be approximated by an exponential relationship which is consistent with experimental observations and predictions using the free-fall arch theory. An analytical model is proposed to estimate the rate of soil loss for cohesionless soil, and the soil flow rate can be calculated using an erosion cavity model based on the law of mass conservation. A kinetic model is extended to predict the soil velocity during erosion which is verified with laboratory measurements.

An Approximate Solution for Two-Dimensional Groundwater Infiltration in Sewer Systems

Quantitative Methods for Groundwater Infiltration into Sewer System

An Approximate Model on Three-Dimensional Groundwater Infiltration in Sewer Systems.

Two-dimensional Pipe Leakage Through a Line Crack in Water Distribution Systems

An analytical solution for steady seepage into a defective pipe

Mathematical Model and Analytical Solution for Groundwater Seepage in Confined Aquifer Subjected to Well Pumping Without Penetrating Overlying Aquiclude

Improved Model for Contaminant Intrusion Induced by Negative Pressure Events in Water Distribution Systems

Analytical Study of Seepage Flow into A Lined Tunnel in A Semi-Infinite Aquifer

Modeling Soil Loss By Water Infiltration Through Sewer Pipe Defects

Analytical Solution for Steady-State Groundwater Inflow into a Circular Tunnel in Anisotropic Soils

Three-dimensional pipe leakage assessment in water distribution system

Physical modeling on sand erosion around defective sewer pipes under the influence of groundwater

A Coupled Discrete Element Model for the Simulation of Soil and Water Flow Through an Orifice

Modeling Pollutant Transport in Overland Flow over Non-Planar and Non-Homogenous Infiltrating Surfaces

Semi-analytical Solution for Groundwater Ingress into Lined Tunnel

Semi analytical Solutions on Seepage Field of Twin Tunnels

Analytical Solutions for Seepage Field of Underwater Tunnel

Analytical Solutions of Steady a Seepage Field for Deep-Buried Tunnel with Grouting Ring Considering Anisotropic Flow

Analytical solutions for the steady-state seepage field in a finite seabed with a lined tunnel

Analytical solutions to seepage field of underwater twin parallel tunnels

Physical and Analytical Modeling of Soil Loss Caused by a Defective Sewer Pipe with Different Defect Locations