Abstract:Diesel engine emissions for on-road, stationary and marine applications are regulated in the United States via standards set by the Environmental Protection Agency (EPA). A major component of diesel exhaust that is difficult to reduce is nitrogen oxides (NOx). Selective catalytic reduction (SCR) has been in use for many years for stationary applications, including external combustion boilers, and is promising for NOx abatement as a retrofit for mobile applications where diesel compression ignition engines are used. The research presented in this paper is the first phase of a program focused on the reduction of NOx by use of a stand-alone urea injection system, applicable to marine diesel engines typical of work boats (e.g., tugs). Most current urea SCR systems communicate with engine controls to predict NOx emissions based on signals such as torque and engine speed, however many marine engines in use still employ mechanical injection technology and lack electronic communication abilities. The system developed and discussed in this paper controls NOx emissions independentof engine operating parameters and measures NOx and exhaust flow using the following exhaust sensor inputs: absolute pressure, differential pressure, temperature, and NOx concentration. These sensor inputs were integrated into an independent controller and open loop architecture to estimate the necessary amount of urea needed, and the controller uses pulse width modulation (PWM) to power an automotive fuel injector for airless urea delivery. The system was tested in a transient test cell on a 350 hp engine certified at 4 g/bhp-hr of NOx, with a goal of reducing the engine out NOx levels by 50%. NOx reduction capabilities of 41-67% were shown on the non road transient cycle (NRTC) and ICOMIA E5 steady state cycles with system optimization during testing to minimize the dilute ammonia slip to cycle averages of 5-7 ppm. The goal of 50% reduction of NOx can be achieved dependent upon cycle. Further research with control optimization, urea distribution and possible use of oxidation catalysts is recommended to improve the NOx reduction capabilities while minimizing ammonia slip.

Experimental and Numerical Analysis of NOx Reduction in Marine Urea-Scr System

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Numerical Simulation to Reduce NOx of Diesel Engine Urea-SCR System

Study on Catalytic Activity and Kinetics of Urea-SCR Processes for NOx Removal from a Marine Diesel Exhaust Flow

Numerical Simulation of Urea Aqueous Solution Injection Process in A Selective Catalytic Reduction System

Kinetics analysis of catalytic processes for marine diesel Urea-SCR system

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Numerical Simulation of SCR of NOx with NH 3

Research on Simulation of Urea-Scr Injection System for Marine Diesel Engine

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Performance Optimization of High-pressure SCR System in a Marine Diesel. Part II: Catalytic Reduction and Process

Ammonium-Salt Formation and Catalyst Deactivation in the SCR System for a Marine Diesel Engine

Numerical Simulation of SCR of NOx with NH3 on Fe-based Catalyst

Investigation on the Simulation of SCR Chemical Reaction

Reaction Mechanism and Chemical Kinetics of NH3-NO/NO2-SCR System with Vanadium-Based Catalyst under Marine Diesel Exhaust Conditions

Development of A 1d Urea-Scr System Model Coupling with Wall Film Decomposition Mechanism Based on Engine Bench Test Data

Numerical Simulation and Optimization of Flow Field in the SCR Denitrification System on a 600 MW Capacity Units

Design and testing of an independently controlled urea SCR retrofit system for the reduction of NOx emissions from marine diesels

New Experimental Results of NO Removal from Simulated Marine Engine Exhaust Gases by Na2S2O8/urea Solutions

Optimal Design of Selective Catalyst Reduction Denitrification System Using Numerical Simulation.

Experiment and Simulation of Ammonia Distribution Uniformity for Diesel Engine Urea-SCR