Abstract:High-temperature heat pipes are often used as heat exchangers in nuclear reactors because of their remarkable advantages in terms of thermal conductivity, isothermal properties, and self-actuation. To ensure the safe operation and efficient heat transfer of a reactor system, it is necessary to analyze the transient heat transfer performances of heat pipes. The working temperature range of the high-temperature heat pipe is 800–1,300 K when sodium is selected as the working fluid. A network system consisting of the thermal resistances can be used to analyze heat pipe transients. For a high-temperature thermosiphon, the existence of a liquid pool and a liquid film will affect the overall thermal resistance and temperature distribution. In this paper, a thermal resistance network model including convection and phase changes was established, a linear differential equation was established based on the energy conservation equation, and code was developed based on this differential equation to solve the thermal resistance and temperature field equations of the heat pipe. It was found that the temperature of numerical calculation in each region was in good agreement with the experimental results. To simulate a complex reactor environment, a power wave was introduced to explore the influence of the heat source on the thermal resistance and temperature field. It is found that with the increase of heating power, the temperature of each region of the heat pipe also increases, and the time required for the heat pipe to reach equilibrium decreases. In addition, the variations of the thermal resistance and temperature field with different heat pipe sizes and cooling modes at the condensation section under variable-power conditions were explored.

Comparative Analysis Of Pipe Flow-Resistance Characteristic Coefficient Identification Methods In Heating Network

The Basic Study on Hydraulic Regime Calculation of Hot Water Network by Basic Loop Analytical Method

Identification of flow resistance coefficient and fault diagnosis in district heating networks

Determination and Application of Comprehensive Specific Frictional Resistance in Heating Engineering

Study of Pressure Drop-Flow Rate and Flow Resistance Characteristics of Heated Porous Materials under Local Thermal Non-Equilibrium Conditions

Dynamic Modeling of Integrated Energy Cooling and Heating Supply System Based on System Identification

Decoupling Control and Simulation for Variable Flow Heating Systems

Monitoring and Analysis of Heat Emission of Domestic Hot-water Pipe Network in Student Villages of Zhejiang University

A Power Flow Analysis Method for the Integrated Electricity-Heat System in Distribution Network Based on Forward/backward Iterations

Analysis methodology during heat transfer in fluid domain: Conduction-advection thermal resistance in parallel

The Research of 1D / 3D Coupling Simulation on Pump and Pipe System

Pneumatic Resistance Network Analysis and Dimension Optimization of High Pressure Electronic Pneumatic Pressure Reducing Valve

Numerical investigation on thermal behavior of high temperature heat pipe based on thermal resistance network model

Steam Heating Network Simulation

Field measurement and analysis on typical issues of hot water distribution networks in heat pump systems for centralized space heating systems

A response factor method to quantify the dynamic performance for pipe-embedded radiant systems

APPLICATION OF DIFFERENT TURBULENT MODELS IN CALCULATION OF FLOW RESISTANCE IN PIPELINES AND COMPARISON THEREOF

Leakage And Blockage Detection In Water Network Of District Heating System

Pipe Roughness Identification of Water Distribution Networks: The Full Turbulent Case

Comparing Between 3D Finite-element Method and Thermal-circuit Method of Calculating Thermal-resistances in the Thermal Field of Three-gorge Hydrognerator

Online Identification of Boiler Heat Storage Coefficient for Accurate Analysis of Primary Frequency Regulation of Steam Unit