Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

Analysis On The Dynamic Response Of Ke Projectiles Penetrating Into Semi-Infinite And Oblique 2024-O Targets

Elastic-plastic dynamic response of slender projectiles penetrating into 2024-O aluminum targets

Numerical Simulation of the Elastic-Plastic Dynamic Response of a Slender Kinetic Energy Penetrator

An Analytical Model for Penetration into Finite Thickness Metallic Target Struck by Rigid Sharp-nosed Projectiles

Numerical Analysis of Deformation and Failure of Penetration into Concrete Target by Projectile

A Computational Study on the Overload Characteristic Curves of Projectile Penetrating Metal Object

Penetration of Aluminum Targets by Ogive-Nosed Projectiles at Oblique Angles

Dynamic Behavior of a Slender Projectile on Oblique Penetrating into Concrete Target

Research on Oblique Penetration of Projectiles into Targets of Different Materials

Structural optimization design and structural response of elliptical-section penetration projectiles

Study of Various Conical Projectiles Penetration into Inconel-718 Target

Comparative study of numerical simulations of projectile penetration into metal targets

Structural response of the concrete target obliquely penetrated by a grooved-tapered projectile

Numerical Simulation Of High-Speed Projectile Oblique Penetration Into The Concrete Target

Numerical Simulation of Rigid Projectiles Penetration into Concrete Targets with Different Warhead Shapes

Oblique Penetration of Spherical Projectile into Low-Carbon Steel Target: Experiment, Theory, 3D Penetration Model

Ballistic Characteristics on Oblique Penetrating Multi-Layer Aluminium Targets by Annular Groove Projectile

Simulation and experiment of the oblique penetration of projectile into concrete target

Analytical and experimental study on elliptical cross-section double-ogive-nose projectile penetration into plain concrete target

Dynamic response of a projectile perforating multi-plate concrete targets

Numerical Simulations of Oblique-Angle Penetration by Deformable Projectiles into Concrete Targets