Abstract:The accurate numerical simulation of projectile penetration process is a complex challenge. Experimental investigation of these time-dependent non-linear events is expensive and time-consuming. In this paper, 3-D numerical simulations are carried out to estimate the penetration performance of designed penetrators against the double and triple brick-wall, plain concrete wall and light armor targets at impact velocities of 120 to 300 m/s, undergoing normal and oblique impacts. In all simulations, both the projectile and targets are modeled using Lagrange solver facility, available in ANSYS/Autodyn. During penetration process, targets experience severe grid deformation in the region local to the penetrator. Highly distorted elements are removed from the calculation using erosion strain algorithm. The simulation results suggest that at maximum velocity flat-nose (FN) projectile successfully perforate all the targets with significant residual velocity, for both normal and maximum oblique impact scenarios. For impact velocity of 120 m/s, the FN projectile perforated the armor and concrete targets but was not able to penetrate and cross through these targets. However, both brick-wall targets were perforated at normal and maximum oblique angle with sufficient residual velocity. The validation of the calculated results and numerical setup were made with experiments against double and triple brick-wall targets for impacting velocity of 170 m/s. Good agreement between the experimental and estimated projectile residual velocity has been achieved. In contrast to FN projectile, the ogive-nose penetrator calculated results has shown ricocheting behavior on impacting the light armor target at minimum velocity and maximum obliquity. The FN projectile has shown better perforation and penetration performance against light armor and domestic targets. The projectile minimum velocity is also estimated numerically to fully penetrate three different types of targets. These results would be beneficial for the designers and operators to get the desired performance against domestic and light armor targets with sureness. Keywords: Numerical simulation, Oblique impact, Perforation, Penetration, Brick-wall

Numerical Simulation Of High-Speed Projectile Oblique Penetration Into The Concrete Target

Investigation on the anti-penetration performance of the steel/nylon sandwich plate

Numerical Simulation of Rigid Projectiles Penetration into Concrete Targets with Different Warhead Shapes

Experimental and 3D Mesoscopic Numerical Simulation Study of Kinetic Projectile Penetrating into Concrete

Research on Oblique Penetration of Projectiles into Targets of Different Materials

Numerical simulation of the disk fragment impacting resistance of plate target

Numerical Simulation of Penetration in Concrete Sheet Based on SPH Method

Numerical Analysis of Deformation and Failure of Penetration into Concrete Target by Projectile

Penetration trajectory of rigid projectile in the heterogeneous meso-scale concrete target

Numerical Studies of Penetration in Light Armor, Concrete and Brick-Wall Targets

Three-dimensional numerical simulation of projectile penetration into concrete and steel fiber reinforced concrete

Numericai Simulation on Non-Normal Penetration into Reinforced Concrete

Experimental Studies on Kinetic Projectile's Direct Penetrations with Low-speed Against Reinforced Concrete Targets

Research on mass loss and nose shape evolution of kinetic energy projectiles penetrating concrete at high velocity

Numerical Simulation of Multifunctional Projectile Penetrating Reinforced Concrete Target Plate Based on Sensor Data Acquisition

Numerical studies on resistance of concrete target under rigid projectile impact using Perzyna-type visco-damage model

Penetration Analysis of Driving Weapons Precursory Shaped Charge Based on LS-DYNA

Analytical and experimental study on elliptical cross-section double-ogive-nose projectile penetration into plain concrete target

Numerical Simulation of Penetration of Ceramic/Metal Composite Armour

The Influence of Target Mesh on the Simulation Results of High Velocity Projectile Penetration

Evaluation of semi‐analytical model for rigid projectile penetration into concrete/metal targets