Abstract:Stirling-type pulse tube cryocoolers (SPTCs) working at liquid-helium temperatures are attractive in space applications because they have advantages of high reliability, compactness, etc. However, the refrigeration efficiency is as low as 0.5% of Carnot efficiency or less. A method of increasing the cross-sectional area of the regenerator at the colder part is proposed in this paper, so as to reduce the heat-associated enthalpy flow at the cold end and improve the performance of the regenerative refrigerators at liquid-helium temperatures, and it is verified through experiments for the first time. Two kinds of variable cross-sectional structures are used in the experiments, which both increase the volume of the regenerator at the colder part. The no-load temperature of the refrigerator reaches 3.87 K, which is about 0.14 K lower than that of the refrigerator with a uniform cross-sectional regenerator under the same working conditions, and the coefficient of performance (COP) is increased by 66% at 4.2 K, and the precooling temperature is 16 K in this case. Theoretical analyses show that there are several reasons for reducing the heat-associated enthalpy flow at the cold end, including: (1). increase of the heat transfer area between the working fluid and the matrix; (2). increase of the total heat capacity of the matrix at the cold end. It is found that the lower the refrigeration temperature, the more serious the real gas effect, resulting in a more significant improvement. However, the increase in the cross-sectional area causes some side effects of reducing both the impedance of the regenerator and the flow rate of the working gas, resulting in a lower heat transfer coefficient. A smaller benefit is got as the refrigeration temperature rises, and the improvement of the COP tends to vanish at about 6 K. It is also found that the performance improvement is more significant when the regenerative efficiency is lower. This new method should provide a reference for further improving the performance of the regenerative refrigerator at liquid-helium temperatures.

Nonideal-gas Effect in Regenerators

Experimental Investigation of Regenerator Matrices on Performance of Pulse Tube Cooler

Influence of Input Acoustic Power on Regenerator’s Performance

Real Gas Effects on the Temperature Profile of Regenerators

Simulation and analysis of influence of pressure ratio on regenerator performance

Characteristics of Steady and Oscillating Flows Through Regenerator

Investigation On The Regenerator Performance Using Gas Mixtures

On the Heat Conduction Losses of Pulse Tube and Regenerator at Temperature Range of 300-4K

Discussion On Regenerator Performance Improvement With Binary Gas Mixture

Dynamic Behavior in Oscillating Flow Regenerators with Thermal Diffusion Effects

A New Tapered Regenerator Used for Pulse Tube Refrigerator and Its Optimization

Varying the Cross-Sectional Area of the Regenerator for Improving the Refrigeration Efficiency at Liquid-Helium Temperatures

Influence of Compression-Expansion Effect on Oscillating-Flow Heat Transfer in A Finned Heat Exchanger

Energy Transfer and Conversion in the Allam Cycle with a Multi-Stream Heat Exchanger

Experimental Study of the Oscillating Flow Characteristics for a Regenerator in a Pulse Tube Cryocooler

Modeling of Heat Transfer and Oscillating Flow in the Regenerator of A Pulse Tube Cryocooler Operating at 50 Hz

A Study Of Oscillating Flow Characteristics Of Regenerators In A High Frequency Pulse Tube Refrigerator

The Effect of the Aftercooler on the Regenerator Temperature Non-Uniformity in a High-Capacity Pulse Tube Cryocooler

Reduction of real gas losses with a DC flow in the practical regenerator of the refrigeration cycle

Real Gas Features on the Performance of Pulse Tube Cryocoolers

A numerical study of elastocaloric regenerators of tubular structures