Abstract:It is extremely difficult to obtain high output power with silicon based processes, which presents one of the greatest challenges for realizing fully integrated transceivers, especially at millimeter-wave frequencies. For this reason, various power combining methods have been proposed to achieve higher power levels.In this paper, a novel power combining method suitable for millimeter-wave applications is presented. The power combining network is synthesized in package utilizing wafer level packaging technology, with an array of power sources of moderate output power capability assumed to be distributed on chip, which means applying further combining in addition to existing on-chip power combining scheme for potentially even higher output power is possible.The power combining network is composed of more basic power combining units, each consisting of one substrate integrated waveguide (SIW) resonator coupling four lambda/4 standing-wave resonators, which can be synthesized using two quarter-wavelength vertical vias with one end open and the other end shorted. For power combining purpose, the open end of each lambda/4 resonator is connected to the differential output of one on-chip power source, while the shorted end is realized using one of the two metal plates of the SIW resonator. The coupling between the SIW resonator and lambda/4 resonators is through slotting on the metal plate to allow magnetic leakage so that oscillation in lambda/4 resonators will excite the SIW resonator to oscillate. As the quality factor of the SIW resonator is much larger than those of lambda/4 resonators, energy is mainly confined in the cavity of the SIW resonator so that power combing is achieved.Example design for 60 GHz application is detailed in the paper with simulation results using commercial CST software showing the effectiveness of the power combining method.

Design of High-Power Cw Signal Generators for Wimax Network Planning

Novel Millimeter-Wave Power Combining Utilizing Wafer Level Packaging Technology

Design of Tri-Band Antenna for WiMAX

Design of WCDMA Linear Power Amplifier

High efficiency class-E RF power amplifier for wireless power transfer system

Study on W-Band Hybrid Integrated Broad Band Signal Source

A 2.469∼2.69GHz AlGaN/GaN HEMT power amplifier for IEEE 802.16e WiMAX applications

A Reconfigurable Baseband Circuit Applied for Wimax Low-If Receivers

Fully-integrated CMOS Power Amplifier Design for WiMAX Application with Semi-Lumped Transformer

Design of a High-Linearity RF Front-End with IP2 Calibration for SAW-less WCDMA Receivers.

High Efficiency RF Transmitter System Architecture Investigation for Mobile WiMAX Applications

Rf Transmitter Architecture Investigation for Power Efficient Mobile Wimax Applications

Design Methodology of the Power Receiver with High Efficiency and Constant Output Voltage for Megahertz Wireless Power Transfer

A high-linearity receiver RF front-end with a high-performance 25%-duty-cycle LO generator for WCDMA/GSM applications

The Design of VHF Wide-band Power Amplifier

Modeling and Simulation of A Powerful Signal Generator in Terahertz Regime

A Design Of Wide-Band Power Amplifier For Wireless Comunications

Design of a 324 MHz 200 Kw CW Waveguide-to-Coaxial Adaptor for Radio Frequency Quadrupole Microwave System

Analysis and Design of a High-Linearity Receiver RF Front-End with an Improved 25%-Duty-cycle LO Generator for WCDMA/GSM Applications

Tri-Band CPW-Fed Stub-Loaded Slot Antenna Design for WLAN/WiMAX Applications

Design Techniques for Wideband CMOS Power Amplifiers for Wireless Communications