Abstract:Abstract Atmospheric pressure plasma jet (APPJ) was used to clean nitrogen-containing carbon films (C–N) fabricated by plasma-assisted chemical vapor deposition method employing the plasma surface interaction linear device at Sichuan University (SCU-PSI). The properties of the contaminated films on the surface of pristine and He-plasma pre-irradiated tungsten matrix, such as morphology, crystalline structure, element composition and chemical structure were characterized by scanning electron microscopy, grazing incidence x-ray diffraction and x-ray photoelectron spectroscopy. The experimental results revealed that the removal of C–N film with a thickness of tens of microns can be realized through APPJ cleaning regardless of the morphology of the substrates. Similar removal rates of 16.82 and 13.78 μ m min −1 were obtained for C–N films deposited on a smooth pristine W surface and rough fuzz-covered W surface, respectively. This is a remarkable improvement in comparison to the traditional cleaning method. However, slight surface oxidation was found after APPJ cleaning, but the degree of oxidation was acceptable with an oxidation depth increase of only 3.15 nm. Optical emission spectroscopy analysis and mass spectrometry analysis showed that C–N contamination was mainly removed through chemical reaction with reactive oxygen species during APPJ treatment using air as the working gas. These results make APPJ cleaning a potentially effective method for the rapid removal of C–N films from the wall surfaces of fusion devices.

Mechanism and Verification of Plasma Cleaning of Organic Contaminant on Aluminum Alloy Surface

The Mechanism Study of Low-Pressure Air Plasma Cleaning on Large-Aperture Optical Surface Unraveled by Experiment and Reactive Molecular Dynamics Simulation

Nonequilibrium Plasma Cleaning of Organic Contaminants on the Surface of Diffraction Gratings

Investigation on mechanism of oxide removal and plasma behavior during laser cleaning on aluminum alloy

Comparing Medium Pressure Dielectric Barrier Discharge (DBD) Plasmas and Classic Methods of Surface Cleaning/activation of Pure Mg for Biomedical Applications

Plasma Cleaning Technology of Organic Pollutants on Aluminized Diffraction Grating Surface

In situ plasma cleaning of large-aperture optical components in ICF

Influence of Plasma Treatment on Surface Characteristics of Aluminum Alloy Sheets and Bonding Performance of Glass Fiber-Reinforced Thermoplastic/Al Composites

Experimental and numerical simulation analysis of laser paint removal of aluminum alloy

In-situ Cleaning Organic Contaminants on SiO2 Sol-Gel Antireflection Film by Low-Pressure Air Plasma

Mechanism and Quality Evaluation of Laser Cleaning of Aluminum Alloy

Spectral Diagnosis of in Situ Plasma Cleaning in Large-Aperture Optical Components: Reactive Species Characterization and Prediction of Cleaning

Evaluation of Laser Cleaning for Defouling of Marine Biofilm Contamination on Aluminum Alloys

Surface Cleaning Using an Atmospheric-Pressure Plasma Jet in $\hbox{o}_{2}/\hbox{ar}$ Mixtures

Surface Cleaning Using An Atmospheric-Pressure Plasma Jet In O-2/Ar Mixtures

Low-Temperature Plasma Treatment of Aluminum for Improved Surface Bonding

The Characterization of Laser-Induced Particles Generated from Aluminum Alloy in High Power Laser Facility

Cleaning of nitrogen-containing carbon contamination by atmospheric pressure plasma jet

Optimization of electrolytic plasma polishing process and surface performance analysis for 6061 aluminum alloy

Research Progress and Challenges in Laser-Controlled Cleaning of Aluminum Alloy Surfaces

Determination on Surface Morphology of Laser Non-Destructive Cleaning Coatings on Aviation Aluminum Alloy