Abstract:In this work, high energy synchrotron X-ray diffraction was used during tensile testing of an as-cast eutectic AlCoCrFeNi2.1 high entropy alloy. Aside, from determining for the first time the volume fractions of existing phases, we further detail their role on the alloy deformation behavior. The two major phases, a soft disordered FCC and a hard ordered B2 BCC, were observed to exhibit a stress partitioning effect which can be used to modulate the mechanical response of the material based on the relative volume fraction of each phase. Dislo-cation density analysis revealed that the soft FCC phase had a significantly higher dislocation density right after the onset of plastic deformation. This is attributed to the existence of strain gradients across the lamellar structure, where the hard B2 BCC prevents free deformation of the FCC phase. Nonetheless, despite the increase of the dislocation density in the soft FCC phase, calculations of the strengthening effects induced by generation of dislocations are more significant in the hard B2 BCC phases, as this phase is primarily responsible for the strength increase in the alloy. Besides, the evolutions in dislocation density of the soft FCC and hard B2 BCC phases during tensile deformation obtained from synchrotron X-ray diffraction data are consistent with the evolution of KAM determined by EBSD characterization. Also, lattice strain analysis across two principal directions (parallel and perpendicular to the loading axis) reveals that for these specific orientations there is a preferential deformation of the hard FCC planes which can be related to the deformation response of specific lattice planes at distinct ori-entations, as well as to the phase partitioning stress behavior.

Deformation Behavior Study in a Model Dual Phase System of Copper–martensitic Steel Using In-Situ Synchrotron X-ray Diffraction

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

In-situ investigation of strengthening and strain hardening mechanisms of Cu-added medium-Mn steels by synchrotron-based high-energy X-ray diffraction

Deformation Behavior and Strengthening Effects of an Eutectic AlCoCrFeNi2.1 High Entropy Alloy Probed by In-Situ Synchrotron X-ray Diffraction and Post-Mortem EBSD

Investigation of ductile damage in dual phase steel during tensile deformation by in situ X-ray computed tomography

Evolution of Microstructure and Deformation Mechanisms in a Metastable Fe42Mn28Co10Cr15Si5 High Entropy Alloy: A Combined In-Situ Synchrotron X-ray Diffraction and EBSD Analysis

Strain-Hardening Behaviors of Dual Phase Steels with Microstructure Features

High-energy X-ray Diffuse Scattering Studies on Deformation-Induced Spatially Confined Martensitic Transformations in Multifunctional Ti–24Nb–4Zr–8Sn Alloy

Simultaneous Multiscale Measurements on Dynamic Deformation of a Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction

Effects of Mechanical Deformation on Dislocation Density and Phase Partitioning in 4130 Steel

In Situ Study of Cementite Deformation and Its Fracture Mechanism in Pearlitic Steels

Synchrotron Study on Load Partitioning Between Ferrite/martensite and Nanoparticles of a 9cr ODS Steel

Multiscale Measurements on Temperature-Dependent Deformation of A Textured Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction

In-situ neutron diffraction investigation of two-stage martensitic transformation in a 13%Mn steel with serrated deformation

Strain-Hardening Behavior of Dual-Phase Steel under Multistress States

Micromechanical behavior of eutectoid steel quantified by an analytical model calibrated by in situ synchrotron-based X-ray diffraction

Semi in-situ investigations on deformation-induced micro-damage in high-strength dual-phase steels

Study Of The Mechanical Behavior Of Dual-Phase Steel Based On Crystal Plasticity Modeling Considering Strain Partitioning

Shear fracture mechanism in micro-tension of an ultrafine-grained pure copper using synchrotron radiation X-ray tomography

Microscale Deformation of A Tempered Martensite Ferritic Steel: Modelling and Experimental Study of Grain and Sub-Grain Interactions

Study on Uniaxial Tensile Deformation of Bainite/ferrite Dual Phase Steel