Abstract:Ceramic cores are an essential part to produce aeroengine turbine blades by investment casting. In recent years, vat photopolymerization (VPP) 3D printing has emerged as a promising technique for fabricating ceramic cores with complex structures due to its advantages of being moldless, low cost, etc. However, how to improve the properties of VPP 3D printed ceramic cores has always been a key bottleneck in industry. In this study, in-situ Y3Al5O12 (YAG) enhanced alumina-based ceramic cores with excellent comprehensive properties were fabricated by VPP 3D printing. Alumina-based ceramic core with in-situ generated YAG phase during the sintering process could reduce the high-temperature deflection to almost one-tenth of a pure alumina ceramic core without decreasing the apparent porosity. Furthermore, the lattice characteristics of the YAG phase and Y3+ segregation were clarified as the main factors in the improvement of the high-temperature deflection resistance and apparent porosity of ceramic cores. The microstructure demonstrated that the increase of fine powders could narrow down the interlayer gap, and the irregular arrangement of ceramic particles could result in the diversification of sintering grain morphologies. With optimal process parameters, the sintering shrinkage of VPP 3D printed alumina-based ceramic cores in X, Y, and Z directions were 3.8 %, 3.7 %, and 4.8 %, respectively. The apparent porosity, flexural strength, and high-temperature deflection were 40.8 %, 16.1 MPa, and 0.63 mm, respectively. This study has reached an excellent balance between high apparent porosity and low high-temperature deflection of ceramic cores, which provides an important reference for the industrialization of 3D printed ceramic cores.

Fabrication of Ceramic Cores Via Layered Extrusion Forming Using Graphite As Pore-Forming Agent

Fabrication of Nanocrystalline Zro2 Particle Reinforced Aluminum Alloy Composite by Squeeze Casting Route

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Effect of Type and Content of Pore-forming Agents on Properties of Porous Alumina Membrane Support

Innovative ceramic paste for stereolithography additive manufacturing alumina core applied in turbine blade casting

Fabrication of Al2O3 ceramic cores with high porosity and high strength by vat photopolymerization 3D printing and sacrificial templating

Fabrication of Silica-Based Ceramic Cores with Internal Lattice Structures by Stereolithography

Additive manufacturing of low-shrinkage alumina cores for single-crystal nickel-based superalloy turbine blade casting

Direct ink writing additive manufacturing of porous alumina-based ceramic cores modified with nanosized MgO

Alumina-Based Ceramic Core Nano-Composites For Investment Casting

Influence of Fabrication Process on Magnetic Properties of Co-Finemet Nanocrystalline Powder Core

Alumina-based ceramic cores prepared by vat photopolymerization and buried combustion method

Fabrication of Porous Alumina Ceramics with Directional Pore Channels Structure by Freeze-Gel Casting Processing

Additive manufacturing of Al2O3 ceramic core with applicable microstructure and mechanical properties via digital light processing of high solid loading slurry

Fabrication of alumina ceramics with high flexural strength using stereolithography

Fabrication of Α-Alo(oh)·sio2 with Core-Shell Structures by Heterogeneous Nucleation-and-growth Processing

The influence of sintering procedure and porosity on the properties of 3D printed alumina ceramic cores

Enhanced 3D Printed Alumina Ceramic Cores Via Impregnation

Microstructure and mechanical properties of 3D-printed nano-silica reinforced alumina cores

In-situ Y3Al5O12 enhances comprehensive properties of alumina-based ceramic cores by vat photopolymerization 3D printing

Microstructure and properties evolution of silicon-based ceramic cores fabricated by 3D printing with stair-stepping effect control