Abstract:SOLPS-ITER is used for modeling divertor plasmas in the experimental shot on the EAST tokamak with a carbon divertor. The modeling uses real divertor geometry and an MHD equilibrium from the shot. The modelled divertor configurations include upper single null (USN), disconnected double null (DDN) and lower single null (LSN). D-0, D+1, e(-) and carbon impurity species sputtered from the first wall are included in the multi- fluid simulations. Neutral particles are traced with EIRENE in which neutral-neutral collisions in triangular grids are considered. The default physics models in the code are employed. The cross-field transport coefficients D, chi(e) and chi(i) deduced from the profile measurements at the targets are used with the assumption of chi(i) = chi(e), some of the deduced D are modified in the SOL and private regions and D, chi(e), chi(i) in the core are adjusted in order to match better the experimental measurement at the target plates. Employed D, chi(e) and chi(i) drop from the core to the SOL, they may drop to neoclassic level within the edge transport barriers (ETBs). A ballooning effect on the transport coefficients is introduced. The computational contour profiles of electron temperature in the divertor regions and the computational profiles of plasma pressure and electron temperature at the mid-plane (the upstream) and at the target plate show the sheath limited (low recycling) operation regime. The calculated profiles of electron density n(e), electron temperature T-e, particle flux f, parallel ion saturation current jsat and parallel power flux P along the target plates of the divertor are compared to the experimental measurements. Using the deduced and adjusted cross-field transport coefficients, when the measurement errors are considered the calculated and measured profiles have a relatively good match, the computational profiles are similar to the measured profiles, the profiles peaked at the separatrix strike points. The most peak values f(s) of calculated profiles are in the range of the measured error-bars f(e) +/- d, only in several matched profiles f(s) is out of the range of the errorbar, but, relative error errorp does not exceed 46.55%. When full drifts are taken into account in the entire SOL and the private flux regions the calculated profiles have better match to the measured profiles and the modeling results show the drifts enhance the divertor asymmetry.

Comparison of OEDGE and EDGE2D‐EIRENE predictions of the scrape‐off layer conditions for attached plasmas

Electric Probe Measurements at Edge Region During H‐Mode Discharges in KSTAR

Testing validity of 1D models for impurity fraction scalings for divertor detachment with EDGE2D-EIRENE

Progress in DIII-D Towards Validating Divertor Power Exhaust Predictions

Study of Scrape-Off-Layer Width in Ohmic and Lower Hybrid Wave Heated Double-Null Divertor Plasma in East

Predictive modelling for EAST divertor operation

Modelling studies of SOL-divertor plasmas in EAST toKoćamak with ohmic shots

Simulation of Divertor Heat Flux Width on EAST by BOUT++ Transport Code

Parametric scaling of power exhaust in EU-DEMO alternative divertor simulations

SOLPS Analysis of Changes in the Main SOL of DIII-D Associated with Divertor Detachment Vs Attachment and Closure Vs Openness

Statistical characterization of turbulence in the boundary plasma of EAST

Modelling Studies Of Sol-Divertor Plasmas In East Tokamak With Ohmic Shots

Comparison of reduced model predictions for divertor detachment onset and reattachment timescales in ASDEX Upgrade and JET experiments

Disconnection of edge coherent mode between the outer midplane and divertor target in EAST H-mode plasma

Reversed-direction 2-point modelling applied to divertor conditions in DIII-D

Validated edge and core predictions of tungsten erosion and transport in JET ELMy H-mode plasmas

Edge turbulence and divertor heat flux width simulations of Alcator C-Mod discharges using an electromagnetic two-fluid model

SOLPS-ITER Modeling of SOL-divertor Plasmas with Different Configurations in EAST

First results of EAST edge modeling with SOLPS‐ITER 3.2.0 on Extended Grid

Numerical Studies of the Influence of Seeding Locations on D-SOL Plasmas in EAST

Experimental Investigation of Scrape-off Layer Blob High Density Transition in L-mode Plasmas on EAST