Long-pulse H-mode operation with stored-energy monitoring for detachment feedback control with a new lower tungsten divertor in EAST
Yuqiang Tao,Guo Sheng Xu,Kai Wu,Qingquan Yang,Liang Wang,Q P Yuan,Yifeng Wang,Xin Lin,Lingyi Meng,Genfan Ding,Lin Yu,Ran Chen,Jianbin Liu,Ning Yan,Heng Lan,Pengjun Sun,Kedong Li,Jichan Xu,Yanmin Duan,Qing Zang,Yifei Jin,Ling Zhang,Shouxin Wang,Kangning Geng,Ruirong Liang
DOI: https://doi.org/10.1088/1741-4326/acd014
IF: 3.3
2023-04-27
Nuclear Fusion
Abstract:One of the key challenges for future fusion research is to mitigate the high steady-state heat load on the divertor target plates, and divertor detachment offers a promising solution. EAST has developed several feedback control methods for divertor detachment. However, when an off-normal event momentarily disturbs the main plasma, impurity seeding may still be conducted by these methods for detachment, which probably drives the main plasma further away from its stable equilibrium or even causes the disruption. These off-normal events include excessive impurity seeding, loss of heating and dust droplets, which are not rare in present tokamak experiments, especially in long-pulse operation. To compensate the drawback of these methods, we propose and develop a module of stored-energy monitoring to ensure stable plasmas in long-pulse operation. The stored energy usually decreases when the main plasma is away from its stable equilibrium, which is suitable to monitor the state of the main plasma. Once the stored energy falls below a certain threshold, the module actively switches off the impurity seeding system. Without impurity seeding, the main plasma can recover with the increase of the stored energy. Only when the stored energy exceeds another threshold, does the module switch on the impurity seeding to continue the detachment operation. The module function has been verified during the EAST radiative divertor experiments in the newly-upgraded lower tungsten divertor. A typical ~20 s discharge in grassy-ELM H-mode regime with ~5 MW source heating power is demonstrated with divertor partial detachment and a good energy confinement by active impurity seeding (50% neon, 50% D2). The energy confinement factor is maintained at a high level, i.e., H_(98,y2)~1.1. Electron temperature in the core region only has slight change after the impurity seeding, while electron density has a ~10% increase. Furthermore, ion temperature near the axis also has a remarkable increase. These achievements provide an important demonstration for the actively-controlled radiative divertor to mitigate the heat loads with a good core confinement, which is an essential step towards steady-state operation of fusion reactor.
physics, fluids & plasmas