Abstract:The appropriate embedment of the cylindrical rods in porous media not only accelerates the rich‐methane flame propagation but also promotes the conversion of methane to syngas. When the 8–120 cylindrical rod is embedded in the burner, the downstream propagation time is shortened by 73.40%, and the highest syngas concentration is obtained. Porous media combustion greatly improves the combustion of low calorific value gas (LCG), and appropriate heat control contributes to optimizing the flame evolution. To obtain the dynamic characteristics of lean‐rich combustion, an enhanced heat‐recirculating burner is built by embedding the cylindrical rod with high thermal conductivity. The temperature distribution and gas products are investigated under different rod parameters and operating conditions. The results indicate that the reduction of the equivalence ratio and inlet velocity are both beneficial for the upstream propagation of rich‐methane flame, which has an opposite trend to lean combustion. Regardless of the direction in which the rich‐methane flame propagates, the flame propagates the fastest as the diameter of the cylindrical rod is 8 mm. When the 8–120 cylindrical rod is embedded in the burner, the downstream propagation time is shortened by 73.40%. The appropriate embedment of the cylindrical rods in porous media not only accelerates the rich‐methane flame propagation but also promotes the conversion of methane to syngas. Moreover, the decrease in pellet diameter is also conducive to increasing syngas production. The above conclusions provide theoretical support for the efficient and clean utilization of LCG in the porous media.

Porous medium burner for gas fuel

Porous medium combustor for gaseous fuel

Experimental and Numerical Study on the Combustion Characteristics of Premixed Methane/Air in Porous Media Burner

Combustion and Heat Transfer of Premixed Natural Gas in a Porous Media Burner

Investigation on Premixed Combustion in Porous Medium Burner

Methane/Air Fuel-Rich Combustion in a Catalyst Enhanced Two-Layer Porous Media Burner

Lean Biogas-Air Mixture Combustion on Porous Burner with a Flamethrower Ignition System

Pore-level numerical simulation of methane-air combustion in a simplified two-layer porous burner

Modulation of Heat Transfer in a Porous Burner Based on Triply Periodic Minimal Surface

Startup and Combustible Limit of Porous Medium Built-in Swiss-roll Burner

Combustion and thermal performance of a novel preheated miniature combustor with a flame holder and various porous medium materials

Experimental investigation on flame stability and emissions of lean premixed methane–air combustion in a developed divergent porous burner

Experimental study on the premixed lean-burn in alumina particles based porous burner

Low-Calorific Gas Combustion in A Two-Layer Porous Burner

Experimental investigation on dynamic characteristics of methane/air combustion in double‐layer pellets porous media

Experimental Study on Premixed Combustion in Two-Layer Porous Media with Embedded Heat Exchangers

Experimental study of industrial low nitrogen porous media burner

Effect of the Cross-Section of a Porous Burner on the Combustion Stability Limit of Premixed Oxy-Methane Flames

Premixed Combustion in A Porous Burner with Different Fuels

Flame Propagation of Premixed Gas with Enhanced Heat Recirculation: Dynamic Characteristics of Lean and Rich Combustion

Transient Combustion Characteristics of Methane-Hydrogen Mixtures in Porous Media Burner