Abstract:The impedance-based stability criterion (IBSC) is increasingly being researched and tested for the analysis and prognosis of harmonic stability or converter-driven stability. Due to the necessary division into two different subsystems for the application of the IBSC (e.g. depicting the grid and loads), frequency-dependent impedances representing the small-signal characteristics are necessary to model these subsystems. Load modeling is particularly necessary for grid-forming systems with active control loops (e.g. voltage-controlled inverters) since interactions between voltage-controlled and current-controlled components can occur. Due to a large number of systems and components as well as the related number of manufacturers in low-voltage grids, the extensive analytical modeling of all components and types is a challenge. A conceivable alternative is the experimental extraction of component impedances based on measurements of the terminal behavior. In this paper, a test bench is presented and used that includes different household appliances representing residential loads. These appliances are individually measured and the frequency-dependent impedances are extracted. From the extracted impedances, requirements are derived for the measurement and modeling. One key contribution of this paper is the analysis of the frequency resolution and the demonstration of advantages resulting from a regression-based calculation. It is shown that a linearly decreasing frequency resolution can be used, which can reduce the measurement time at the expense of accuracy. Furthermore, an approach to a black-box model parameter fitting is shown based on transfer functions with an a priori unknown model order. The results demonstrate that a model order can be found from which all measured household appliances can be modeled. In a final step, the individual impedances are analytically aggregated for larger grids into an equivalent impedance, and a sensitivity analysis is carried out by varying the individual penetration rates.

International Journal of Emerging Electric Power Systems Integrated Kalman-Independent Component Analysis Method for Harmonic Current Estimation on an Interconnected Four Bus Simulated and Laboratory Model

Unified Model Based Harmonics and Reactive Current Detection

Simplified Modeling of Power Electronic Interfaced Load Considering Harmonics

Comparison Of Control Strategies For Active Power Filter In Three-Phase Four-Wire Systems

An Agent-Based Distributed State Estimation Approach for Interconnected Power Systems

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Variable Parameter Kalman Filter Based Dynamic Harmonic State Estimation for Power Systems with Wind Energy Integration

Harmonic Detection Method Based on IEC Standards and PSO Spectrum Estimation

Simulation for Harmonic Analysis of an Integrated Power System.

Identification of Multiple Harmonic Sources in Cyber-Physical Energy System Using Supervised Independent Component Analysis

Multi-source data driven harmonic spectrum estimation of substation feeder current

Data-Driven Adaptive Unscented Kalman Filter for Time-varying Inertia and Damping Estimation of Utility-scale IBRs Considering Current Limiter

Hybrid Independent Component Analysis (H-ICA) with Simultaneous Analysis of High-Order and Second-Order Statistics for Industrial Process Monitoring

A Digital Signal Processor Based Performance Evaluation of Three-phase Four-wire Shunt Active Filter for Harmonic Elimination, Reactive Power Compensation, and Balancing of Non-linear Loads under Non-ideal Mains Voltages

Extraction of frequency-dependent impedances of residential loads in low-voltage grids for harmonic stability assessment

Dynamic state estimation of power system using hybrid whale-tunicate optimized unscented Kalman filter based on wide area measurement systems

Evaluation of Harmonic Contributions for Multi Harmonic Sources System Based on Mixed Entropy Screening and an Improved Independent Component Analysis Method

Ensemble kalman filter and particle filter-based state estimation on electrical power systems

Power Quality State Estimation for Distribution Grids Based on Physics-Aware Neural Networks—Harmonic State Estimation

Performance assessment of two active power filter control strategies in the presence of non-stationary currents

Harmonic State Estimation for Distribution Networks based on Multi-Measurement Data