Abstract:Ammonia, as an alternative fuel for internal combustion engines, can achieve nearly zero carbon emissions. Although the development of the pure ammonia engine is limited by its poor combustion characteristics, ammonia–hydrocarbon mixed combustion can effectively improve the combustion of ammonia fuel. With the increase in the ammonia fuel proportion in the fuel mixture, a large number of nitrogen oxides (NOX) and unburned ammonia may be discharged, which have a poor impact on the environment. In this study, the performance of selective catalytic reduction (SCR) aftertreatment technology in reducing NOX and ammonia emissions from ammonia–diesel dual-fuel engines was investigated using simulation. A good cross-dimensional model was established under the coupling effect, though the effect of a single-dimensional model could not be presented. The results show that when the exhaust gas in the engine cylinder is directly introduced into the SCR without additional reducing agents such as urea, unburned ammonia flowing into SCR model is in excess, and there will be only ammonia at the outlet; however, if the unburned ammonia fed into the SCR model is insufficient to reduce NO, the ammonia concentration at the outlet will be 0. NOX can be 100% effectively reduced to N2 under most engine conditions; thus, unburned ammonia in exhaust plays a role in reducing NOX emissions from ammonia–diesel dual-fuel engines. However, when the concentration of unburned ammonia in the exhaust gas of an ammonia–diesel dual-fuel engine is large, its ammonia emissions are still high even after the SCR. In addition, the concentrations of N2O after SCR do not decrease, but increase by 50.64 in some conditions, the main reason for which is that by the action of the SCR catalyst, NO2 is partially converted into N2O, resulting in an increase in its concentration at the SCR outlet. Adding excessive air or oxygen into the SCR aftertreatment model can not only significantly reduce the ammonia concentration at the outlet of the model without affecting the NOX conversion efficiency of SCR, but inhibit N2O production to some extent at the outlet, thus reducing the unburned ammonia and NOX emissions in the tail gas of ammonia–diesel dual-fuel engines at the same time without the urea injection. Therefore, this study can provide theoretical guidance for the design of ammonia and its mixed-fuel engine aftertreatment device, and provide technical support for reducing NOX emissions of ammonia and its mixed fuel engines.

Experimental demonstration of NO x reduction and ammonia slip for diesel engine SCR system

Experimental demonstration of NOx reduction and ammonia slip for diesel engine SCR system

Investigation on an Innovative Sorption System to Reduce Nitrogen Oxides of Diesel Engine by Using Carbon Nanoparticle

Experimental Study of Ammonia Slip of Diesel Engine Urea Selective Catalytic Reduction System in Transient Condition

Ammonia storage and slip in a urea selective catalytic reduction catalyst under steady and transient conditions

In Situ DRIFTS Studies of NH3-SCR Mechanism over V2O5-CeO2/TiO2-ZrO2 Catalysts for Selective Catalytic Reduction of NOx

Experimental investigation on the characteristics of ammonia storage for heavy-duty diesel engine SCR catalyst

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Experimental study of SCR DeNO X efficiency at low exhaust gas temperatures

Urea injection control strategy in urea-selective catalytic reduction for heavy-duty diesel engine under transient process

Ammonia storage and slip under steady and transient state in close-coupled SCR

Nitrogen Oxides and Ammonia Removal Analysis Based on Three-Dimensional Ammonia-Diesel Dual Fuel Engine Coupled with One-Dimensional SCR Model

Study on Diesel Engine Selective Catalytic Reduction Performance at Different Atmospheric Pressures Using the Response Surface Method

Review on Selective Catalytic Reduction Technology of Diesel Engines

An Ethanol SCR for NOx Purification: Performance Evaluation on Engine Bench and Demonstration on Bus

Model-based NH3 Adaptation Method for SCR Control

Improvement of NOX Reduction Rate of Urea SCR System Applied for an Non-Road Diesel Engine

Tuning the Standard SCR Reaction Kinetics to Model NO Conversion in a Diesel Engine Exhaust SCR Catalyst System Under Steady State Conditions in 1D and 3D Geometries Using Ammonia Gas as the Reductant

The regulation of Ca2+ accumulation and phospholipid metabolism in human platelets.

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Experimental and Modeling Study on the Mechanism and Sensitive Parameters of the Thermal DeNOx Process