Abstract:<p>Fused deposition molding and sintering (FDMS) technology has the characteristics of low cost and low damage to diamonds. In order to explore more possibilities of additive manufacturing diamond tools, FDMS technology was considered to manufacture Co-based diamond composites at different temperatures in this paper. Also, specimens of Co-based diamond composites were manufactured under the same sintering process by using the powder hot-pressed sintering technology. And the matrix microstructure and properties of the specimens made by those two different technologies were analyzed and compared. The results show that a lot of porosity defects were developed inside the specimens manufactured by FDMS. This is because of the specific process characteristics of FDMS. Also, the matrix forms a special coating state for diamond particles due to the binder system used in this study, which causes some diamond particles to suffer slight thermal damage. These all will reduce the density and holding ability of the FDMS specimens. However, when the sintering temperature increases from 800 °C to 880 °C, the performance loss of FDMS samples caused by the porosity defects gradually decreases, thereby reducing the performance difference when comparing with the powder hot-pressed sintering specimens. In addition, the matrix structural uniformity of the FDMS specimens is significantly improved during this process, and the fracture feature changes from intergranular fracture to transgranular fracture. But there is still a certain difference in the overall performance of the two kinds of specimens at the optimal sintering temperature. Therefore, the further optimization of FDMS process parameters and binder system is of great significance for the application of FDMS in diamond tools.</p>

Method for preparing sintered metal matrix diamond saw blade used for cutting qfn packaging device

Saw-type sintering metal base diamond saw blade for cutting QFN (Quad Flat Non-leaded) package substrate

Thin metal-based diamond cutting slice for cutting semiconductor chip BGA encapsulation body in saw mode and manufacturing method thereof

Optimization Design of Diamond Circular Saw-Blade with Discontinuous Cutting and Uneven Distribution for Cutting Thin-Walled Tubes

Investigation on the machining performance of copper-based diamond ultra-thin dicing blades manufactured by fused deposition modeling and sintering (FDMS)

Influence of sintering temperature on dicing performances of metal-bonded diamond blades on sapphire

Development of Diamond Tools for Superprecision Machining with Compositionally Graded Layers from Silicon Carbide Shank to Diamond Chip.

High-Speed Dicing of SiC Wafers with 0.048 mm Diamond Blades via Rolling-Slitting

Preparation and characterization of ultra-thin dicing blades with different bonding properties

The role of pre-alloyed powder combined with pressure-less microwave sintering on performance of superhard materials

Preparation and performance study of electroplated Ni–W/diamond ultrathin dicing blades

Effect of Mechanical Pretreatment on Nucleation and Growth of HFCVD Diamond Films on Cemented Carbide Tools with a Complex Shape

Development of metal bonded diamond abrasive tools

Study on process and manufacturability of metal-bonded diamond grinding wheel fabricated by selective laser melting (SLM)

Microstructure and performance characterization of Co-based diamond composites fabricated via fused deposition molding and sintering

Fabrication and performance evaluation of metal bond diamond tools based on aluminothermic reaction

Study on the Fabrication and Cutting Performance of Hfcvd Diamond Coated Silicon Nitride Inserts

Cutting performance evaluation of nickel-plated graphite Fe-based diamond saw blades

Performance Evaluation of Diamond Coated Milling Cutter Fabricated Based on Electrostatic Self-Assembly Seeding

Sol gel method based method for preparing composite nano diamond thin films

Effect of Pretreatment Strategy on the Microstructure, Mechanical Properties and Cutting Performance of Diamond Coated Hardmetal Tools Using HFCVD Method