Abstract:There is growing interest in the development of novel materials and devices capable of ionizing radiation detection for medical applications. Organic semiconductors are promising candidates to meet the demands of modern detectors, such as low manufacturing costs, mechanical flexibility, and a response to radiation equivalent to human tissue. However, organic semiconductors have typically been employed in applications that convert low energy photons into high current densities, for example, solar cells and LEDs, and thus existing design rules must be re-explored for ionizing radiation detection where high energy photons are converted into typically much lower current densities. In this work, we report the optoelectronic and X-ray dosimetric response of a tissue equivalent organic photodetector fabricated with solution-based inks prepared from polymer donor poly(3-hexylthiophene) (P3HT) blended with either a non-fullerene acceptor (5Z,5'Z)-5,5'-((7,7'-(4,4,9,9-tetraoctyl-4,9-dihydro-s-indaceno[1,2-b:5,6-b']dithiophene-2,7-diyl)bis(benzo[c][1,2,5]thiadiazole-7,4-diyl))bis(methanylylidene))bis(3-ethyl-2-thioxothiazolidin-4-one) (o-IDTBR) or a fullerene acceptor, [6,6]-phenyl-C61-butyric acid methyl ester (PCBM). Indirect detection of X-rays was achieved via coupling of organic photodiodes with a plastic scintillator. Both detectors displayed an excellent response linearity with dose, with sensitivities to 6 MV photons of 263.4 ± 0.6 and 114.2 ± 0.7 pC/cGy recorded for P3HT:PCBM and P3HT:o-IDTBR detectors, respectively. Both detectors also exhibited a fast temporal response, able to resolve individual 3.6 μs pulses from the linear accelerator. Energy dependence measurements highlighted that the photodetectors were highly tissue equivalent, though an under-response in devices compared to water by up to a factor of 2.3 was found for photon energies of 30-200 keV due to the response of the plastic scintillator. The P3HT:o-IDTBR device exhibited a higher stability to radiation, showing just an 18.4% reduction in performance when exposed to radiation doses of up to 10 kGy. The reported devices provide a successful demonstration of stable, printable, flexible, and tissue-equivalent radiation detectors with energy dependence similar to other scintillator-based detectors used in radiotherapy.

Stable and Printable Direct X-Ray Detectors Based on Micropyramid Ω-Bi2o3 with Low Detection Limit

A High-Sensitivity Flexible Direct X-ray Detector Based on Bi2O3/PDMS Nanocomposite Thin Film

Direct X.ray Detectors Based on PDMS Films with Low Detection Limit and High Flexibility

Lattice‐Gradient Perovskite KTaO3 Films for Ultra‐Stable and Low‐Dose X‐Ray Detector

Robust Fabrication of Hybrid Lead‐Free Perovskite Pellets for Stable X‐ray Detectors with Low Detection Limit

Lattice-Gradient Perovskite KTaO<sub>3</sub> Films for an Ultrastable and Low-Dose X-Ray Detector

Flexible Polymer X-ray Detectors with Non-fullerene Acceptors for Enhanced Stability: Toward Printable Tissue Equivalent Devices for Medical Applications

Ultrasensitive and stable X-ray detection using zero-dimensional lead-free perovskites

X-Ray Detector-on-Plastic With High Sensitivity Using Low Cost, Solution-Processed Organic Photodiodes

Toward Low-Voltage and High-Sensitivity Direct X-ray Detectors Based on Thick Bulk Heterojunction Organic Device

Air‐Stable and Flexible Photodiode for X‐Rays Detection Based on a Hybrid Perovskite Active Layer and Organic Interlayers

Highly Sensitive X-ray Detector Made of Layered Perovskite-Like (nh4)(3)bi2i9 Single Crystal with Anisotropic Response

Stable perovskite single-crystal X-ray imaging detectors with single-photon sensitivity

High‐sensitive and fast MXene/silicon photodetector for single‐pixel X‐ray imaging

Flexible Single Microwire X‐Ray Detector with Ultrahigh Sensitivity for Portable Radiation Detection System

Molecular Doping of Flexible Lead-Free Perovskite-Polymer Thick Membranes for High-Performance X-Ray Detection

Highly sensitive X-ray detector made of layered perovskite-like (NH4)3Bi2I9 single crystal with anisotropic response

On characterizing X-ray detectors for low-dose imaging

Flexible Lead-Free X-ray Detector from Metal–Organic Frameworks

High sensitivity organic inorganic hybrid X-ray detectors with direct transduction and broadband response